BS EN 60947-7-2:2009
低压开关设备和控制设备.第7-2部分:辅助设备.铜导线用保护导线接线端子排

Low-voltage switchgear and controlgear - Part 7-2:Ancillary equipment - Protective conductor terminal blocks for copper conductors

标准号

BS EN 60947-7-2:2009

发布

2009年

发布单位

英国标准学会

当前最新

BS EN 60947-7-2:2009

 

 

引用标准

IEC 60439-1 AMD 1-2004 IEC 60439-1-1999 IEC 60715 AMD 1-1995 IEC 60715-1981 IEC 60947-1-2007 IEC 60947-7-1

被代替标准

06/30157054 DC-2006 BS EN 60947-7-2:2002

适用范围

This part of IEC 60947 specifies requirements for protective conductor terminal blocks with PE function up to 120 mm (250 kcmil) and for protective conductor terminal blocks with PEN function equal to and above 10 mm (AWG 8) with screw-type or screwless-type clamping units, primarily intended for industrial applications. Protective conductor terminal blocks are used to form the electrical and mechanical connection between copper conductors and the fixing support. lt is applicable to protective conductor terminal blocks for the connection of round copper conductors with or without special preparation having a cross-section between 0,2 mm and 120 mm (AWG 24 and 250 kcmil), intended to be used in circuits of a rated voltage not exceeding 1 000 V a.c. up to 1 000 Hz or 1 500 V d.c., most commonly in conjunction with terminal blocks according to IEC 60947-7-1. This standard may be used as guide for − protective conductor terminal blocks requiring the fixing of special devices to the conductors, for example quick connect terminations or wrapped connections, etc.; – protective conductor terminal blocks providing direct contact to the conductors by means of edges or points penetrating the insulation, for example insulation displacement connections, etc. Where applicable in this standard, the term “clamping unit” has been used instead of the term “terminal”. This is taken into account in case of reference to IEC 60947-1.

BS EN 60947-7-2:2009相似标准

推荐