BS 4500:2009
公差和配合.锥形配合系统和从C=1:3到1:500,长度从6 mm至630 mm直径小于等于500 mm的锥形的公差系统指南

Limits and fits - Guidance for system of cone (taper) fits and tolerances for cones from C = 1:3 to 1:500, lengths from 6 mm to 630 mm and diameters up to 500 mm

标准号

BS 4500:2009

发布

2009年

发布单位

英国标准学会

当前最新

BS 4500:2009

 

 

引用标准

BS EN 20286-1

被代替标准

BS 4500-5:1988 BS 4500-4:1985 09/30192596 DC-2009

适用范围

This British Standard gives guidance on a system of cone fits and tolerances for cones from C = 1:3 to 1:500 and lengths from 6 mm to 630 mm. The appropriate tolerances of this British Standard can also be used for prismatic workpieces, for example wedges. This British Standard applies to cones which are dimensioned and toleranced according to BS ISO 3040, Method 1, Basic Taper method. This means that the tolerances limit the variation of penetration of mating surfaces, each surface being within two limiting profiles of the same taper corresponding to the maximum material condition (MMC) and the least material condition (LMC). This British Standard is derived from BS EN 20286, and is a complement to BS EN ISO 1119. NOTE For dimensioning and tolerancing cones on drawings, see BS ISO 3040.

BS 4500:2009相似标准

推荐

谁引用了BS 4500:2009 更多引用