ASTM E925-2009
光谱狭缝宽度不超过2nm的紫外线-可见光分光光度计的校准监测的标准实施规程
Standard Practice for Monitoring the Calibration of Ultraviolet-Visible Spectrophotometers whose Spectral Slit Width does not Exceed 2 nm
ASTM E925-2009 中，可能用到以下耗材
非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 ASTM E925-2009 前三页，或者稍后再访问。
点击下载后，生成下载文件时间比较长，请耐心等待......
- 标准号
- ASTM E925-2009
- 发布日期
- 2009年
- 实施日期
- 废止日期
- 无
- 中国标准分类号
- N53
- 国际标准分类号
- 71.040.50 (Physicochemical methods of analysis)
- 发布单位
- US-ASTM
- 适用范围
This practice permits an analyst to compare the performance of an instrument to the manufacturer''s supplied performance specifications and to verify its suitability for continued routine use. It also provides generation of calibration monitoring data on a periodic basis, forming a base from which any changes in the performance of the instrument will be evident.
1.1 This practice covers the parameters of spectrophotometric performance that are critical for testing the adequacy of instrumentation for most routine tests and methods within the wavelength range of 200 to 700 nm and the absorbance range of 0 to 2. The recommended tests provide a measurement of the important parameters controlling results in spectrophotometric methods, but it is specifically not to be inferred that all factors in instrument performance are measured.
1.2 This practice may be used as a significant test of the performance of instruments for which the spectral bandwidth does not exceed 2 nm and for which the manufacturer''s specifications for wavelength and absorbance accuracy do not exceed the performance tolerances employed here. This practice employs an illustrative tolerance of x00B1;1 % relative for the error of the absorbance scale over the range of 0.2 to 2.0, and of x00B1;1.0 nm for the error of the wavelength scale. A suggested maximum stray radiant power ratio of 4 x00D7; 10-4 yields x003C;1 % absorbance bias at an absorbance of 2. These tolerances are chosen to be compatible with many chemical applications while comfortably exceeding the uncertainty of the certified values for the reference materials and typical manufacturer''s specifications for error in the wavelength and absorbance scales of the instrument under test. The user is encouraged to develop and use tolerance values more appropriate to the requirements of the end use application. This procedure is designed to verify quantitative performance on an ongoing basis and to compare one instrument''s performance with that of other similar units. Refer to Practice E275 to extensively evaluate the performance of an instrument.
1.3 This practice should be performed on a periodic basis, the frequency of which depends on the physical environment within which the instrumentation is used. Thus, units handled roughly or used under adverse conditions (exposed to dust, chemical vapors, vibrations, or combinations thereof) should be tested more frequently than those not exposed to such conditions. This practice should also be performed after any significant repairs are made on a unit, such as those involving the optics, detector, or radiant energy source.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.