BS 1868:1975+A1:1990
石油、石化及联合工业用钢制止回阀(有法兰及对焊端)用规范

Specification for steel check valves (flanged and butt-welding ends) for the petroleum, petrochemical and allied industries

被代替

标准号

BS 1868:1975+A1:1990

发布

1975年

发布单位

英国标准学会

替代标准

BS 1868:1975+A1:1990(2010)

当前最新

BS 1868:1975+A1:1990(2010)

 

 

被代替标准

74/74150 DC BS 1868:1975

适用范围

This British Standard specifies requirements for cast or forged steel check valves with flanged or butt-welding ends of the following types: a) swing, for vertical or horizontal flow (see Figure 1); b) lift: i) piston type, for angle or horizontal flow (see Figure 2); ii) ball type, for angle or horizontal flow (see Figure 3); iii) ball type, for vertical flow (see Figure 4); iv) disk type, for vertical flow (see Figure 5). The terms “vertical”, “horizontal” and “angle” relate to the axes of the body ends. When swing check valves are used in vertical lines the flow must be in an upward direction. For the purposes of this standard any line with a slope (upward or downward) of 5° or less is deemed to be horizontal. In the case of angle pattern valves the inlet should be vertical.

BS 1868:1975+A1:1990相似标准

推荐