ISO/TS 17892-6-2004
土工勘查和检验.土壤的实验室检验.第6部分:落锥体试验

Geotechnical investigation and testing - Laboratory testing of soil - Part 6: Fall cone test

标准号

ISO/TS 17892-6-2004

发布日期

2004年10月

实施日期

废止日期

无

中国标准分类号

P13

国际标准分类号

13.080.20;93.020

发布单位

国际标准化组织

代替标准

ISO 17892-6-2017

适用范围

This document specifies the laboratory determination of undrained shear strength of both undisturbed and remoulded specimen of saturated fine grained cohesive soils by use of a fall-cone. This document specifies the fall-cone test, in which a cone is allowed to fall with its tip towards a soil specimen, whereupon the penetration of the cone into the soil is measured. Tests performed according to this test yield penetration values which can be used to estimate the undrained shear strength. The test is applicable to both undisturbed and remoulded soil test specimen. For undisturbed soil test specimen, the results of the test are dependent on the quality of the specimen. Because of possible effects of anisotropy, it can also differ depending on what undrained shear strength the relation refers to. The evaluated value of the undrained shear strength of the 'undisturbed' soil refers to its state during the test in the laboratory. This value is not necessarily indicative of the undrained shear strength of the soil in its natural state in the field. Therefore, the test should be regarded as an index test. NOTE 1 For non-homogeneous soil samples, this method yields values of the undrained shear strength which are less representative for the bulk shear strength of the sample than other tests involving a larger volume of soil. NOTE 2 For disturbed soil samples and fissured soil samples this method normally yields higher strength values than tests involving a larger volume of soil.

ISO/TS 17892-6-2004系列标准

谁引用了ISO/TS 17892-6-2004 更多引用