ANSI Z400.1/Z129.1-2010
美国国家工作场所危险化学品–危害评估和安全数据表和预防标签准备标准

American National Standard for Hazardous Workplace Chemicals – Hazard Evaluation and Safety Data Sheet and Precautionary Labeling Preparation

标准号

ANSI Z400.1/Z129.1-2010

发布

2010年

发布单位

美国国家标准学会

 

 

适用范围

This Standard applies to the preparation of SDSs and precautionary labeling for hazardous chemicalsused under occupational conditions. It presents basic information on how to develop and write SDSs andprecautionary labels. It also identifies information that must be included to comply with the HCS.Additional information is provided to help comply with state and federal environmental and safety lawsand regulations. Elements of this Standard may also be acceptable for international use. This Standardis not intended to address the distribution of SDSs.This Standard is not intended to provide a rote specification for complying with the HCS or any othergovernment requirements. Safety data sheet and precautionary labeling requirements and definitions aresubject to change. It is the responsibility of the SDS and label preparer to be aware of current HCSrequirements.This Standard must be applied in a manner consistent with all statutory and regulatory requirements,including the United States Occupational Safety and Health Administration (OSHA) HazardCommunication Standard (HCS; 29 CFR 1910.1200) and the substance specific standards (29 CFR1910.1001-1052).There are use-specific statutory and regulatory requirements for some chemical products that are outsidethe scope of OSHA HCS and therefore may have different SDS and/or labeling requirements. Someexamples include:? consumer products regulated by the Federal Hazardous Substances Act (FHSA),? medical products regulated by the Federal Food, Drug and Cosmetic Act (FFDCA),? pesticides regulated by the Federal Insecticide, Fungicide and Rodenticide Act (FIFRA),? materials in transportation regulated by the Department of Transportation (DOT) HazardousMaterials Regulations, and? laboratory chemicals regulated under 29 CFR 1910.1450, the “OSHA Laboratory Standard”.See 29 CFR 1910.1200(b) for information on the scope and application of the HCS.For example, a company that manufactures aspirin tablets does not need to produce and distribute SDSsto individuals that are taking aspirin to treat pain or some other medical condition. This includes aspirintablets taken by a worker in the workplace. In this scenario, the aspirin would fall under the jurisdiction ofthe FDA, not OSHA. However, the company would be required to produce OSHA hazard communicationdocuments (such as an SDS and labels) for workers who may be exposed to aspirin powder during themanufacture of the tablets.It is not the intent of this Standard to substitute for specific regulatory requirements or to list each andevery unique requirement. Where there is a conflict between the applicable regulations and thisStandard, the regulations must take precedence over this Standard. References to the Code of FederalRegulations (CFR) in the Standard are to the January 1, 2009 edition of the CFR.

ANSI Z400.1/Z129.1-2010相似标准

推荐

谁引用了ANSI Z400.1/Z129.1-2010 更多引用