BS 6440:2011
带有供行动不便者使用的开放式或部分封闭式升降通道的电动垂直升降平台.规范

Powered vertical lifting platforms having non-enclosed or partially enclosed liftways intended for use by persons with impaired mobility. Specification


BS 6440:2011




购买全文,请联系:


标准号
BS 6440:2011
发布
2011年
发布单位
英国标准学会
当前最新
BS 6440:2011
 
 
引用标准
BS 7671 BS EN 12015 BS EN 12016 BS EN 12183 BS EN 12184 BS EN 12385-4 BS EN 13411 BS EN 349 BS EN 50214 BS EN 60204-1-2006+A1-2009 BS EN 60529-1992 BS EN 609 BS EN 60947-1-2007 BS EN 60947-4-1-2010 BS EN 81-1-1998+A3-2009 BS EN 81-2-1998+A3-2009 BS EN 953
代替标准
GMKOREA EDS-T-7604-2011
被代替标准
BS 6440:1999
适用范围
This British Standard specifies requirements for the design, manufacture, installation, commissioning, testing, maintenance and dismantling of new permanently installed electrically powered vertical lifting platforms with the following characteristics: • travelling vertically between predefined levels along a guided path where the inclination to the vertical does not exceed 15°; • supported or sustained by wire ropes, chains, rack and pinion, hydraulic cylinder (direct or indirect), screw and nut or scissors mechanisms; • having non-enclosed or partially enclosed liftways; • having non-enclosed or partially enclosed carriers; • having a rated speed that is not greater than 0.15 m/s; • having a travel distance that is not greater than 3.0 m; • sized for use with type A or type B wheelchairs conforming to BS EN 12183 and/or BS EN 12184. It is applicable to lifting platforms that are intended primarily for the transport of persons with impaired mobility, with or without a wheelchair. NOTE 1 The lifting platforms specified in this standard can be used in domestic or non-domestic premises, and can be installed indoors or outdoors. Their installation in some premises might not be practicable. NOTE 2 Although this British Standard is applicable to new lifting platforms, it can also be used as guidance for the refurbishment and re-installation of existing lifting platforms.

BS 6440:2011相似标准


推荐

专家解读:英国插头新标准已强制实施!有这14点变化

带电子元器件插头要求(Annex G)新增:1、 内部携带电子元器件插头需符合EMC要求;2、 带浪涌防护装置插头应符合相应标准要求;3、 带电子开关插头应符合相应标准要求。带有BS1363-1插销产品(Annex I )新增:针对带有BS1363-1插销产品中插头部分考核要求。 本文作者王荟慧威凯电器附件工程部副部长世界认证地图APP特约专家 课程推荐END...

电动升降台(Motorized Z-stages):

     电动升降台是指通过电机驱动,控制台面做上下方向(称Z 轴)运动电动设备。目前我公司电动升降台有几种形式:平移台竖直使用、楔块式升降台、减速机升降台等。相关产品对比见表5。表5      注:平移台竖直使用时,需要重点考虑负载以及负载偏心情况,如果载荷重量和尺寸都较小,而精度要求较高、行程较大时可以考虑使用此种方式。      减速机升降台主要适合大负载情况下使用。...

升降平台使用范例

部分客梯还有空气调节,和电视机乘客观看。有些客运升降轿厢是透明,放在建筑物外墙旁行走,乘客观光用。  货运升降平台是一种必须以人手控制升降机门货运专用升降机械,货运升降机一般比客运升降机大和载重较多,由2000至5000公斤不等,多数都是采用曳引式。货运升降机内一般没有很好装饰,以避免运货时被损坏,,一般都有专门电梯控制人员值守,控制升降机门开关。  ...

关于各种阀门特点和区别你知道多少?

对夹式蝶阀是用双头螺栓将阀门连接在两管道法兰之间,法兰式蝶阀是阀门上带有法兰,用螺栓将阀门上两端法兰连接在管道法兰上。阀门强度性能是指阀门承受介质压力能力。阀门是承受内压机械产品,因而必须具有足够强度和刚度,以保证长期使用而不发生破裂产生变形。球阀球阀是由旋塞阀演变而来。它具有相同旋转90度提动作,不同是旋塞体是球体,有圆形通孔通道通过其轴线。...


谁引用了BS 6440:2011 更多引用





Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号