IEC TS 61000-3-4:1998由国际电工委员会 IX-IEC 发布于 1998-10。
IEC TS 61000-3-4:1998 在中国标准分类中归属于: L06 电磁兼容,在国际标准分类中归属于: 33.100.10 发射。
IEC TS 61000-3-4:1998 电磁兼容性(EMC).第3-4部分:限值.额定电流超过16 A设备的低压供电系统的谐波电流辐射限值 于 2004-11 变更为 IEC 61000-3-12:2004 电磁兼容性(EMC).第3-12部分:与输入电流每相16A和75A的公用低压系统连接的设备产生的谐波电流的限值。
This part of IEC 61000 deals with the emission of disturbances due to harmonics. The recommendations of this technical report are applicable to electrical and electronic equipment with a rated input current exceeding 16 A per phase and intended to be connected to public low-voltage a.c. distribution systems of the following types: - nominal voltage up to 240 V, single-phase, two or three wires; - nominal voltage up to 600 V, three-phase, three or four wires; - nominal frequency 50 Hz or 60 Hz. Other distribution systems are excluded. Tests according to this report are type tests of complete pieces of equipment, for example a speed variable fan, and not of components, for example a converter. Connection of this equipment to the supply generally requires special agreement between the supply authority and the consumer. This consent will depend upon several factors including the expected levels of disturbance caused by the equipment and the actual situation at the connection point to the power supply system. These recommendations specify the information required to enable a supply authority to assess equipment regarding harmonic disturbance and to decide whether or not the equipment is acceptable for connection with regard to the harmonic distortion aspect. NOTE 1 - For these types of equipment only general recommendations on assessment of disturbances can be given. There is no guarantee that the connection of equipment complying with these recommendations will be allowed in all cases, as the consent to connect equipment to the supply depends on the level of disturbance caused by the equipment and the load conditions in the network. NOTE 2 - These recommendations can also be applied to equipment with a lower rated input current but requiring special consent of the supply authority (see IEC 61000-3-2). NOTE 3 - These recommendations are not applicable to active filters. Guidance is given on: a) required short-circuit power for harmonics emitting equipment tested or simulated under specified conditions; b) methods for type tests or simulations.
3-2:2014 电磁兼容性(EMC) -第3-2:限制-谐波电流发射限值(设备输入电流≤16每相A) EN 61000-3-3:2013 电磁兼容性(EMC) 第3-3部分:限值 每相额定电流小于等于16A、不受有条件连接限制的设备用公共低压供电系统电压变化、电压波动和闪烁的限制 吹膜机CE认证...
-2009《电磁兼容 家用电器、电动工具和类似器具的要求 第2部分:抗扰度 产品类标准》GB 17625.1-2012《电磁兼容 限值 谐波电流发射限值(设备每相输入电流≤16A)》GB/T 17625.2-2007《电磁兼容 限值 对额定电流不大于16A的设备在低压供电系统中产生的电压波动和闪烁的限制》0807音视频配套的电源适配器安全标准GB 8898-2011《音频、视频及类似电子设备的安全要求...
国际标准编号 国家标准编号 描 述 电磁兼容抗扰测试标准 IEC 61000-3-2 GB/T 17625.1 低压电气及电子设备发出的谐波电流限值 IEC 61000-3-3 GB/T 17625.2 低压供电系统中额定电流不大于16A的设备的电压波动和闪烁的限值 IEC 61000-4-2 GB/T 17626.2 静电放电抗扰度试验 IEC 61000-4-3 GB/T 17626.3...
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号