ASTM D6587-2012e1
采用自动试验机测定纱线支数的标准试验方法

Standard Test Method for Yarn Number Using Automatic Tester

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 ASTM D6587-2012e1 前三页，或者稍后再访问。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

ASTM D6587-2012e1

发布日期

2012年

实施日期

废止日期

无

国际标准分类号

59.080.20 (Yarns)

发布单位

US-ASTM

适用范围

5.1x00a0;This test method for yarn number is satisfactory for acceptance of commercial shipments and is used in the trade.

5.1.1x00a0;In case of a dispute arising from differences in reported test results when using this Test Method for acceptance testing of commercial shipments, the purchaser and the supplier should either use the referee Test Method D1907 for yarn number or conduct comparative tests to determine if there is a statistical bias between their laboratories. Competent statistical assistance is recommended for the investigation of bias. As a minimum, the two parties should take a group of test specimens that are as homogeneous as possible and that are from a lot of material of the type in question. The test specimens should then be randomly assigned in equal numbers to each laboratory for testing. The average results from the two laboratories should be compared using appropriate statistical analysis and a probability level chosen by the two parties before the testing is begun. If a bias is found, either its cause must be found and corrected or the purchaser and the supplier must agree to interpret future test results with consideration to the known bias.

5.2x00a0;This test method is also used for the quality control for both filament and spun yarns.

1.1x00a0;This test method covers the measurement of yarn number of filament and spun yarns using automated testers. Some of the instruments are stand-alone and others are optional modules for instruments that perform additional tests.

1.1.1x00a0;The instruments are capable of measuring yarn numbers up to 4000 dtex (3600 denier).

Note 1x2014;For determination of yarn number by use of reel and balance, refer to Test Method D1907.

1.2x00a0;The values stated in SI units are to be regarded as standard.

1.3x00a0;This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D6587-2012e1 中可能用到的仪器设备