IEC 60730-2-22:2014由国际电工委员会 IX-IEC 发布于 2014-05,并于 2014-05-15 实施。
IEC 60730-2-22:2014 在中国标准分类中归属于: K31 低压配电电器,在国际标准分类中归属于: 97.120 家用自动控制装置。
本标准有等同采用的 中文版 GB/T 14536.3-2022 电自动控制器 第3部分:电动机热保护器的特殊要求
"This clause of Part 12 is applicable except as follows: Replacement: This part of IEC 60730 applies to the partial evaluation of thermal motor protectors as defined in IEC 60730-1 for household and similar use@ including heating@ air conditioning and similar applications as well as for sealed (hermetic and semi-hermetic type) motorcompressors. NOTE A thermal motor protector is considered an integrated control since its protective functionality is dependent on the correct mounting and fixing in or on a motor and which can only be fully tested in combination with the relevant motor. This dependency is illustrated by: the ability of the thermal motor protector to accurately and reliably sense the heat of the motor windings; thus@ addressing the over-temperature protection due to motor overload conditions; the ability of the thermal motor protector to accurately and reliably sense the current due to motor lockedrotor conditions; thus@ reducing the response time and not being adversely affected by heat-sink at the assembly spot in the application; the influence of the motor's electromagnetic field on the switch behaviour of the thermal motor protector; particularly@ affecting the arc direction between the contacts resulting in uneven wear of the contact material and eventually leading to failure of operation. Requirements concerning the testing of the combination of sealed (hermetic and semihermetic type) motor-compressors and thermal motor protectors are given in IEC 60335-2-34. This standard applies to thermal motor protectors using NTC or PTC thermistors@ additional requirements for which are contained in Annex J. This standard applies to the inherent safety@ to the operating values@ operating times@ and operating sequences@ where such are associated with equipment safety@ and to the testing of thermal motor protectors used in or on household or similar equipment as well as sealed (hermetic and semi-hermetic type) motor-compressors. This standard applies to thermal motor protectors for appliances within@ but not limited to@ the scope of IEC 60335-1 and its Part 2's. NOTE Throughout this standard@ the word ""equipment"" means ""appliance and equipment"". Thermal motor protectors not intended for normal household use@ but which nevertheless may be used by the public@ such as equipment intended to be used by laymen in shops@ in light industry and on farms@ are within the scope of this standard. This standard does not apply to thermal motor protectors designed exclusively for industrial applications. This standard does not apply to other means of motor protection. This standard does not apply to a manual device for opening the circuit. 2 References to ""Part 1"" in this document pertain to the fourth edition of IEC 60730-1 published in 2010."
2021/4/94820200632-T-604家用和类似用途双金属温度控制器修订2021/4/94920200633-T-604家用和类似用途压力式温度控制器修订2021/4/95020203833-T-418海平面观测与影响评价制订2021/4/95120193333-T-606裸眼3D柱透镜光栅膜 光学测量方法制订2021/4/95220203731-T-609建筑用绝热制品 六溴环十二烷的限值制订...
),Amd.1(2008)J60730-2-6(H23)家用和类似用途的自动电控制器-第2-6部分:压力敏感电自动控制器的特殊要求,包括机械要求JIS C 9730-2-6:2010IEC 60730-2-6(2007)J60730-2-7(H23)家用和类似用途的自动电控制器-第2-7部分:定时器和定时开关的特殊要求JIS C 9730-2-7:2010IEC 60730-2-7(2008)J60838...
表 5 菲律宾近期新增的电自动控制器PNS标准序号PNS标准号PNS标准名称1PNS IEC 60730-2-3:2022家用和类似用途电自动控制器–第2-3部分:管形荧光灯镇流器热保护器的特殊要求(IEC 2006版)2PNS IEC 60730-2-8:2022电自动控制器–第2-8部分:电动水阀的特殊要求(包括机械要求)(IEC 2018 w/Amd.1-2021版)3PNS IEC 60730...
No. 94.2《电气设备外壳,环境注意事项》CAN/CSA-C22.2 No. 60950-1《信息技术设备安全 第 1 部分:一般要求》CSA-E60730-1《家用和类似用途自动电气控制-第 1 部分:一般要求》IEC 60068-2-30《环境试验 第 2-30 部分试验 试验 Db循环湿热试》IEC 60068-2-64《环境试验 第 2-64 部分试验试验 Fh 振动、宽带随机抽样》IEC...
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号