ISO 11297-2:2018
地下排水和压力下污水网络用翻新塑料管道系统.第2部分:连续管道的衬里

Plastics piping systems for renovation of underground drainage and sewerage networks under pressure - Part 2: Lining with continuous pipes

标准号

ISO 11297-2:2018

发布

2018年

发布单位

国际标准化组织

当前最新

ISO 11297-2:2018

 

 

引用标准

EN 12201-1:2011 EN 12201-2+A1:2013 EN 12201-3+A1:2012 EN 12201-5:2011 ISO 11295:2017 ISO 11297-1:2018 ISO 12176-1:2017 ISO 12176-2:2008 ISO 4427-1:2007 ISO 4427-2:2007 ISO 4427-3:2007 ISO 4427-5:2007

适用范围

This document, in conjunction with ISO 11297-1, specifies requirements and test methods for pipes and fittings which are part of plastics piping systems installed as continuous pipes in the renovation of underground drainage and sewerage networks under pressure. It is applicable to polyethylene (PE) pipes of three different types: — PE solid wall single layered pipes (nominal outside diameter, dn), including any identification stripes; — PE pipes with co-extruded layers on either or both the outside and inside of the pipe (total outside diameter, dn), as specified in Annex A, where all layers have the same MRS rating; — PE coated pipes (outside diameter, dn) having a peelable, contiguous, thermoplastics additional layer on the outside of the pipe (“coated pipe”), see Annex A. In addition it covers: — jointing of pipe lengths by means of butt fusion; — fabricated and injection-moulded fittings made of PE. It is applicable to PE pipes, fittings and assemblies intended to be used at an operating temperature of 20 °C as the reference temperature. NOTE For applications operating at constant temperatures greater than 20 °C and up to 40 °C, see

推荐