23.160 真空技术 标准查询与下载
共找到 461 条与 真空技术 相关的标准，共 31 页
The method of determining the volume of gas which flows in unit time through the pump inlet are specified. The considered pumps discharge the gas against atmosphere pressure and achieve a limiting inlet pressure less than 100 pa in one stage.
Positive-displacement vacuum pumps; measurement of performance characteristics; part 1: measurement of volume rate of flow (pumping speed)
- ICS
- 23.160
- CCS
- J78
- 发布
- 1993-12
- 实施
Specifies the dimensions for vacuum pipeline fittings (elbows, tees and crosses) for nominal bores from 10 mm to 250 mm of the R5 series.
Vacuum technology; pipeline fittings; mounting dimensions
- ICS
- 23.160
- CCS
- J78
- 发布
- 1993-02
- 实施
本标准规定了溅射离子泵性能测试方法。 本标准适用于抽速大于10Ls(-1)的离子泵。
Performance testing method of sputtering ion pump
- ICS
- 23.160
- CCS
- J78
- 发布
- 1992-12-25
- 实施
- 1993-07-01
本标准规定了单级多旋片式真空泵的型式与基本参数，技术要求，试验方法，检验规则与标志、包装、贮存等。 本标准适用于单级多旋片式真空泵。 本标准不适用于单级油封式旋片真空泵。
Single stage multi-rotary vane vacuum pump
- ICS
- 23.160
- CCS
- J78
- 发布
- 1992-07-20
- 实施
- 1993-01-01
本标准规定了真空刮膜转鼓蒸发器的结构型式与基本参数，技术要求，试验方法，检验规则与包装、运输、贮存等要求。 本标准适用于以过热蒸汽或机械油为加热介质的真空刮膜转鼓蒸发器。
Vacuum wiped film drum-evaporator
- ICS
- 23.160
- CCS
- J78
- 发布
- 1992-07-20
- 实施
- 1993-01-01
The document defines and explains terms related to the subject vacuum gauges.
Vacuum technology; terms and definitions; vacuum gauges
- ICS
- 23.160
- CCS
- J78;N68
- 发布
- 1992-06
- 实施
本标准规定了低真空电磁压差充气阀的型式与基本参数。 本标准行之有效用于DYC-Q型低真空电磁压差充气阀。
Type and basic parameters of low-vacuum electromagnetic differential pressure gas charging valve
- ICS
- 23.160
- CCS
- J78
- 发布
- 1991-07-22
- 实施
- 1992-07-01
本标准规定了普通型式溅射离子泵的技术要求、检验规则、试验方法、包装、贮存等。 本标准适用于JB/T 4081所规定的二级型（L型）和三极型（3L型）的溅射离子泵。
Sputtering ion pump technical conditions
- ICS
- 23.160
- CCS
- J78
- 发布
- 1991-07-22
- 实施
- 1992-07-01
本标准规定了铜丝密封圈的结构尺寸及技术要求。 本标准适用于JB 5278.1规定的真空法兰连接型式。
Structural dimensions of copper wire seal bakeable vacuum flange copper wire seal ring
- ICS
- 23.160
- CCS
- J78
- 发布
- 1991-01-01
- 实施
- 1991-07-01
本标准规定了用于超高真空系统的铜丝密封可烘烤法兰的结构型式与连接尺寸。 本标准适用于压力低于1×10(-5)Pa超高真空系统中用铜丝密封的法兰连接。
Copper wire seal bakeable vacuum flange connection type
- ICS
- 23.160
- CCS
- J78
- 发布
- 1991-01-01
- 实施
- 1991-07-01
本标准规定了钢丝密封真空法兰的结构尺寸及技术要求。 本标准行之有效用于JB 5278.1规定的真空法兰连接型式。
Copper wire seal bakeable vacuum flange flange structure size
- ICS
- 23.160
- CCS
- J78
- 发布
- 1991-01-01
- 实施
- 1991-07-01
Dimensions of Clmped-type Vacuum Couplings
- ICS
- 23.160
- CCS
- 发布
- 1990-01-04
- 实施
이 규격은 방전 및 전리를 사용하는 진공계(이하 진공계라고 한다)에 의해서 진공도를 측정하
Measuring methods of low pressures by discharge and ionization vacuum gauges
- ICS
- 23.160
- CCS
- A50
- 发布
- 1989-12-01
- 实施
- 1989-12-01
The considered method of measurement deals with vapours jet vacuum pumps, diffusions pumps and diffusion-ejector pumps. The dependence of the performance of these pumps on the backing pressure can only be completely described be means of a curve relating the inlet and backing pressure over the range of operation. The recommended test dome and the principle of the test equipment are illustrated.
Vapour vacuum pumps; measurement of performance characteristics; part 2: measurement of critical backing pressure
- ICS
- 23.160
- CCS
- J78
- 发布
- 1989-12
- 实施
- 1989-12-01
The considered pumps discharge the gas against atmosphere pressure and achieve a limiting inlet pressure of less than 100 Pa in one stage. The method adopted is that the ultimate pressure is measured at a specified temperature in a specified form of test dome attached to the inlet of the pump.
Positive-displacement vacuum pumps; measurement of performance characteristics; part 2: measurement of ultimate pressure
- ICS
- 23.160
- CCS
- T78
- 发布
- 1989-11
- 实施
- 1989-11-01
This specification covers only the cooler-Dewar group t o be used in the M1 Thermal Imaging System(TIS).
COOLER-DEWAR GROUP, OR-338/V, OR-339/V
- ICS
- 23.160
- CCS
- J78
- 发布
- 1989-05-17
- 实施
This specification covsrs only the cooler-Dewar group t o be used in the AN/ASQ-170 Target ActheDesignation Sight(TADS) and the AN/AAQ-11 Pilot Night Vision Sensor(PNVS).
COOLER-DEWAR GROUP, OR-336/A, OR-337/A
- ICS
- 23.160
- CCS
- J78
- 发布
- 1989-05-17
- 实施
この規格は，熱険極及び冷陰極電離真空計(以下，真空計という。)を用いて圧力を測定すろ場合の一般的方法について規定する。
Measuring methods of low pressures by hot cathode and cold cathode ionization gauges
- ICS
- 23.160
- CCS
- N11
- 发布
- 1989-03-01
- 实施
