27.080 热泵 标准查询与下载

KS B ISO 13256-2-2022 水源热泵.性能试验和额定值.第2部分:水对水和盐水对水热泵

Water-source heat pumps — Testing and rating for performance — Part 2: Water-to-water and brine-to-water heat pumps

KS B ISO 13256-2:2022 水源热泵.性能试验和额定值.第2部分:水对水和盐水对水热泵

Water-source heat pumps — Testing and rating for performance — Part 2: Water-to-water and brine-to-water heat pumps

DB11/T 1253-2022 地埋管地源热泵系统工程技术规范

Engineering technical specification for buried pipe ground source heat pump system

DB11/T 1254-2022 再生水热泵系统工程技术规范

Reclaimed water heat pump system engineering technical specification

T/GDC 204-2022 以R290为制冷剂的室内热泵热水器技术要求和试验方法

R290为制冷剂的室内热泵热水器产品分类、技术要求及试验方法。

Technical requirements and test methods for indoor heat pump water heaters using R290 as refrigerant

T/GDC 202-2022 复叠式空气源热泵机组

气密性和压力试验、运转、名义工况、高温出水工况等。

Superimposed air-source heat pump unit

T/GDC 203-2022 家用空气源泳池恒温热泵安装规范

家用空气源泳池恒温热泵安装要求、布线要求

Specification for installation of household air source swimming pool constant temperature heat pump

EN 16905-5:2022 燃气吸热发动机驱动热泵.第5部分:加热和冷却模式季节性性能的计算

This part of EN 16905 specifies the calculation of the seasonal performance factor for gas-fired endothermic engine driven heat pumps for heating and/or cooling mode including the engine heat recovery, to be used outdoors. This document only applies to appliances with a maximum heat input (based on net calorific value) not exceeding 70 kW at standard rating conditions. This document only applies to appliances under categories I2H, I2E, I2Er, I2R, I2E(S)B, I2L, I2LL, I2ELL, I2E(R)B, I2ESi, I2E(R), I3P, I3B, I3B/P, II2H3+, II2Er3+, II2H3B/P, II2L3B/P, II2E3B/P, II2ELL3B/P, II2L3P, II2H3P, II2E3P and II2Er3P according to EN 437:2021. This document only applies to appliances having: a) gas fired endothermic engines under the control of fully automatic control systems; b) closed system refrigerant circuits in which the refrigerant does not come into direct contact with the fluid to be cooled or heated; c) where the temperature of the heat transfer fluid of the heating system (heating water circuit) does not exceed 105 °C during normal operation; d) where the maximum operating pressure in the: 1) heating water circuit (if installed) does not exceed 6 bar, 2) domestic hot water circuit (if installed) does not exceed 10 bar. This document applies to GEHP appliances only when used for space heating or space cooling or for refrigeration, with or without heat recovery. This document is applicable to GEHP appliances that are intended to be type tested. Requirements for GEHP appliances that are not type tested would need to be subject to further consideration.

Gas-fired endothermic engine driven heat pumps - Part 5: Calculation of seasonal performances in heating and cooling mode

ISO 5149-4:2022 制冷系统和热泵.安全和环境要求.第4部分:操作、维护、修理和恢复

Refrigerating systems and heat pumps — Safety and environmental requirements — Part 4: Operation, maintenance, repair and recovery

NB/T 11039-2022 畜禽养殖场空气源热泵应用技术规范

Technical specifications for the application of air source heat pumps in livestock and poultry farms

NB/T 11040-2022 家用空气源直膨式地暖热泵机组

Household air source direct expansion floor heating heat pump unit

NB/T 11041-2022 空气源热泵热水器内置式零冷水系统技术条件

Technical conditions for built-in zero cold water system of air source heat pump water heater

T/EES 0012-2022 质 量 分 级 及 “ 领 跑 者 ” 评 价 要 求 基 于 地 埋 管 地 源 热 泵 系 统 的 高 效 能 源 站 运 营 服 务

本文件适用于基于地埋管地源热泵系统的高效能源站（简称：能源站）运营服务质量和企业标准水平评价。相关机构开展质量分级和企业标准水平评估、“领跑者”评价以及相关认证时可参照使用，企业在制定企业标准时也可参照本文件。

Assessment requirements for quality grading and forerunnerHigh efficiency energy station operation service based on buried pipe ground source heat pump system

EN 14511-2:2022 空间加热和制冷用电动压缩机空调,液体冷却装置及热泵.第2部分:试验条件

1.1 The scope of EN 14511-1:2022 is applicable. 1.2 This document specifies the test conditions for the rating of air conditioners, liquid chilling packages and heat pumps, using either, air, water or brine as heat transfer media, with electrically driven compressors when used for space heating and/or cooling. The document also specifies the test conditions for the rating of air-cooled and water(brine)-cooled process chillers. 1.3 This document specifies the conditions for which performance data are to be declared for single duct and double duct units for compliance to the Ecodesign Regulation 206/2012 and Energy Labelling Regulation 626/2011.

Air conditioners, liquid chilling packages and heat pumps for space heating and cooling and process chillers, with electrically driven compressors - Part 2: Test conditions

EN 14511-4:2022 空间加热和制冷用带电驱动压缩机的空调,液体冷却包和热泵.第4部分:要求

1.1 The scope of EN 14511-1:2022 is applicable, with the exception of process chillers. 1.2 This document specifies minimum operating requirements which ensure that air conditioners, heat pumps and liquid chilling packages using either air, water or brine as heat transfer media, with electrical driven compressors are fit for the use designated by the manufacturer when used for space heating and/or cooling.

Air conditioners, liquid chilling packages and heat pumps for space heating and cooling and process chillers, with electrically driven compressors - Part 4: Requirements

EN 14511-3:2022 空调,液体冷却包和电动热泵压缩机空间加热和冷却-第3部分:试验方法

1.1 The scope of EN 14511-1:2022 is applicable. 1.2 This document specifies the test methods for the rating and performance of air conditioners, liquid chilling packages and heat pumps using either air, water or brine as heat transfer media, with electrically driven compressors when used for space heating and cooling. These test methods also apply for the rating and performance of process chillers. It also specifies the method of testing and reporting for heat recovery capacities, system reduced capacities and the capacity of individual indoor units of multisplit systems, where applicable. This document also makes possible to rate multisplit and modular heat recovery multisplit systems by rating separately the indoor and outdoor units.

Air conditioners, liquid chilling packages and heat pumps for space heating and cooling and process chillers, with electrically driven compressors - Part 3: Test methods

22/30445314 DC BS EN 16905-4 燃气吸热发动机驱动的热泵 第 4 部分：测试方法

BS EN 16905-4. Gas-fired endothermic engine driven heat pumps. - Part 4. Test methods

ISO 16494-1:2022 热回收通风机和能量回收通风机.性能试验方法.第1部分:能量相关性能评估指标的制定

This document specifies a method of testing the ventilation and energy related performance of heat recovery ventilators (HRVs) and energy recovery ventilators (ERVs) that do not contain any supplemental heating (except for defrost), cooling, humidification, or dehumidification components. Exchanger types of HRVs and ERVs are a) fixed-plate exchangers (also known as recuperators), b) rotary exchangers, including heat wheels and total energy wheels (also known as regenerators), and c) heat pipe exchangers using a heat transfer medium, excluding those using mechanical pumping, This document does not provide a method for measuring the response of exchangers to the formation of frost.

Heat recovery ventilators and energy recovery ventilators — Method of test for performance — Part 1: Development of metrics for evaluation of energy related performance

T/HSSX 0010-2022 热泵干燥用涡旋式制冷剂压缩机

本标准规定了热泵干燥用涡旋式制冷剂压缩机（以下简称“压缩机勺的基本参数、技术要求、试验方法 和检验规则等。

Scroll refrigerant compressor for heat pump drying

T/HSSX 0009-2022 空气源热泵干燥机组通用技术规范

本标准规定了空气源热泵干燥机组的产品分 类 、技术要求 、试验方法和检验规则等。

General technical specification for air source heat pump drying unit