29.140.30 荧光灯、放电灯 标准查询与下载

KS C 7601-2004 荧光灯(普通照明用)

이 규격은 교류 회로에서 점등되는 일반 조명용 직관형, 둥근형 형광 램프 및 콤팩트형 형광

Fluorescent lamps for general lighting service

LST EN 50107-1-2003/A1-2004 在超过 1 kV 但不超过 10 kV 的空载额定输出电压下工作的标志和发光管装置 第1部分：一般要求

Signs and luminous-discharge-tube installations operating from a no-load rated output voltage exceeding 1 kV but not exceeding 10 kV. Part 1: General requirements

IEC 60901:1996/AMD3:2004 单端荧光灯.性能规范.修改件3

This International Standard specifies the performance requirements for single-capped fluorescent lamps for general lighting service. The requirements of this standard relate only to type testing. Conditions of compliance, including methods of statistical assessment, are under consideration. The following lamp types and modes of operation with external ballasts are included: a) lamps operated with an internal means of starting, having preheated cathodes, for oper-ation on a.c. mains frequencies; b) lamps operated with an external means of starting, having preheated cathodes, for operation on a.c. mains frequencies with the use of a starter, and additionally operating on high frequency; c) lamps operated with an external means of starting, having preheated cathodes, for oper-ation on a.c. mains frequencies without the use of a starter (starterless), and additionally operating on high frequency; d) lamps operated with an external means of starting, having preheated cathodes, for oper-ation on high frequency; e) lamps operated with an external means of starting, having non-preheated cathodes, for operation on high frequency. For some of the requirements given in this standard reference is made to "the relevant lamp data sheet". For some lamps these data sheets are contained in this standard. For other lamps, falling under the scope of this standard, the relevant data are supplied by the lamp manufacturer or responsible vendor.

Single-capped fluorescent lamps - Performance specifications; Amendment 3

AS/NZS 4782.2:2004 双头荧光灯．性能规范．最低能效标准（MEPS）

Specifies performance and energy efficiency specifications for tubular fluorescent lamps of length 550 mm to 1500 mm both inclusive with wattage of 16 watts or more that are within the scope of AS/NZS 4782.1.

Double-capped fluorescent lamps - Performance specifications - Minimum Energy Performance Standard (MEPS)

NF C72-221/A1:2004 放电灯(荧光灯除外).安全规范

Discharge lamps (excluding fluorescent lamps) - Safety specifications.

LST EN 60081-1999/A2-2004 双端荧光灯 性能规格（IEC 60081:1997/A2:2003）

Double-capped fluorescent lamps. Performance specifications (IEC 60081:1997/A2:2003)

DS/EN 62035/A1:2004 放电灯（不包括荧光灯） 安全规范

This standard specifies the safety requirements for discharge lamps (excluding fluorescent lamps) for general lighting purposes. This standard is applicable to low-pressure sodium vapour lamps and to high intensity discharge (HID) lamps, i.e. high-pressure mercury vapour lamps (including blended lamps), high-pressure sodium vapour lamps and metal halide lamps. It applies to single- and double-capped lamps, having caps as listed in annex A. The requirements of this standard relate only to type testing. Conditions of compliance, including methods of statistical assessment, are under condiseration.

Discharge lamps (excluding fluorescent lamps) - Safety specifications

AS/NZS 4782.1:2004 双头荧光灯．性能规范．一般要求（IEC 60081：2000，MOD）

Specifies performance requirements for double-capped fluorescent lamps for general lighting service. This document is an adoption of IEC 60081:1997 and includes Amendment 1:2000 and Amendment 2:2003.

Double-capped fluorescent lamps - Performance specifications - General (IEC 60081:2000, MOD)

LST EN 62035-2001/A1-2004 放电灯（不包括荧光灯） 安全规范（IEC 62035:1999/A1:2003，已修改）

Discharge lamps (excluding fluorescent lamps). Safety specifications (IEC 62035:1999/A1:2003, modified)

ANSI/IESNA LM-73-2004 使用白炽灯或者高强度放电灯的娱乐照明灯具的光度试验的IESNA指南

Describes a standard procedure by which entertainment lighting luminaires, specifically designed for use in the theater or TV environments, can be measured.

IESNA Guide for Photometric Testing of Entertaiment Lighting Luminaires Using Incandescent Filament Lamps or High Intensity Discharge Lamps

SANS 60901:2004 单灯口荧光灯．性能规范

This International Standard specifies the performance requirements for single-capped fluorescent lamps for general lighting service.

Single-capped fluorescent lamps — Performance specifications

KS C 7620-2003(2018) 铁路汽车灯具荧光灯

Fluorescent lighting fixtures for railway vehicles

KS C IEC 61049-2003(2008) 灯具附件管形荧光灯和其他放电灯电路用电容器性能要求

Auxiliaries for lamps－Capacitors for use in tubular fluorescent and other discharge lamp circuits－Performance requirements

KS C IEC 60925-2003(2008) 性能要求 - 直流输入型荧光灯电子镇流器

D.C. supplied electronic ballasts for tubular fluorescent lamps－Performance requirements

KS C 7610-2003 钠灯

This standard is applied to general illumination and also to sodium vapour lamps (hereinafter referred to "lamp"), which has glass tube unified with lighting tube, but not to high pressure sodium vapour lamps with start circuit embedded. - Rated Power Consumption Below 2000 W - B, Bl, I, E or R type Sodium vapour lamps - High pressure sodium vapour Lamps with E26 or E39 type Cap, or low pressure sodium vapour lamps with BY 22D type cap. Note : Unit or figure included in '{ }' are conformed to former unit.

Sodium vapour Lamps

KS C 7604-2003 高压水银灯

This standard is applied to general illumination and also to high pressure mercury vapour lamp (hereinafter referred to "lamp"), which lighting using ballast stipulated in KS C 8104 and using visible spectrum of mercury stipulated as follows. - Rated Power Consumption Below 2000 W - B, BT or R type mercury vapour lamp - Lamp with E26 or E39 type Cap

High pressure mercury vapour lamps

KS C 7620-2003(2023) 铁道车辆用荧光灯器具

Fluorescent lighting fixtures for railway vehicles

KS C 7620-2003 铁路车辆用日光灯具

이 규격은 철도 차량에 사용하는 인버터를 내장한 직류 형광등 기구(이하 “기구”라 한다.)

Luminaries for fluorescent lamps for use in railway vehicles

LST EN 50107-1-2003 在超过 1 kV 但不超过 10 kV 的空载额定输出电压下工作的标志和发光管装置 第1部分：一般要求

Signs and luminous-discharge-tube installations operating from a no-load rated output voltage exceeding 1 kV but not exceeding 10 kV. Part 1: General requirements

SANS 62035:2003 放电灯（荧光灯除外）．安全规程

Specifies the safety requirements for discharge lamps (excluding fluorescent lamps) for general lighting purposes.This International Standard is applicable to low-pressure sodium vapour lamps and to high-intensity discharge (HID) lamps, i.e. high-pressur

Discharge lamps (excluding fluorescent lamps) - Safety specifications