43.180 检查、维修和试验设备 标准查询与下载



共找到 592 条与 检查、维修和试验设备 相关的标准,共 40

本标准规定了电动汽车公用充电站的安全管理规范。 本标准适用于为电动汽车进行充电的充电站。 2 规范性引用文件 下列文件中的内容通过文中的规范性引用而构成本文件必不可少的条款。其中,注日期的引用文件, 仅该日期对应的版本适用于本文件;不注日期的引用文件,其最新版本(包括所有的修改单)适用于本 文件。 GB 50016 建筑设计防火规范 GB 50058 爆炸危险环境电力装置设计规范 GB/T 18487.1 电动汽车传导充电系统 第 1部分 通用要求 GB/T 27930 电动汽车非车载传导式充电机与电池管理系统之间的通信协议 GB/T 31525 图形标志 电动汽车充换电设施标志 DL 5027 电力设备典型消防规程 NB/T 33001 电动汽车非车载传导式充电机技术条件  NB/T 33002 电动汽车交流充电桩技术条件 公用充电站 public charging station  采用整车充电模式为电动汽车提供电能的场所,主要由三台及以上电动汽车充电设备,至少有一台 非车载充电机,并能够在充电过程中对充电设备、动力蓄电池进行状态监控的公共场所。 充电设备 charging equipment 与电动汽车成为动力蓄电池相连接,并为其提供电能的设备,包括车载充电机、非车载充电机、交 流充电桩等设备。 充电系统 EV charging station 由充电站内的所有充电设备、充电电缆及相关辅助设备组成,实现安全充电的系统。 供电系统 EV power-supply system 为充电站的运行提供电源的电力设备和配电线路总称。 监控系统 EV supervisor system 对充电站的供电状况、充电设备运行状态、环境

Operational Safety Management Specifications for Public Charging Stations for Electric Vehicles

ICS
43.180
CCS
S952
发布
2022-07-29
实施
2022-07-29

文件规定了机动车检验机构分级管理与评价的基本要求、评价原则及评价内容等

Classified management and evaluation of motor vehicle inspection agencies

ICS
43.180
CCS
M745
发布
2022-06-21
实施
2022-09-28

文件给出了机动车检验机构管理的术语和定义,规定了机动车检验机构的基本要求、制度与管理体系建设、检测设备及检测场地设施要求、人员要求、评价与改进等内容

Management Regulations for Motor Vehicle Inspection Institutions

ICS
43.180
CCS
M745
发布
2022-06-21
实施
2022-09-28

本文件规定了氢氧汽车积碳清洗机的术语和定义、要求、试验方法、检验规则、标志、使用说明书、包装、运输、贮存。

Hydrogen and oxygen car carbon cleaning machine

ICS
43.180
CCS
C381
发布
2022-06-08
实施
2022-06-08

1   Scope This document specifies an application profile for the implementation of unified diagnostic services (UDS) Internet Protocol (IP) in road vehicles (UDSonIP). UDSonIP references ISO 14229‑1 and ISO 14229‑2 and specifies implementation requirements of the diagnostic services to be used for diagnostic communication on Internet Protocol. This document includes — additional requirements specific to the implementation of UDS on the Ethernet network, and — specific restrictions in the implementation of UDS on the Ethernet network.

Road vehicles. Unified diagnostic services (UDS). Unified diagnostic services on Internet Protocol implementation (UDSonIP)

ICS
43.180
CCS
发布
2022-05-31
实施
2022-05-31

This document specifies the dimensions of the test track for a closed-loop test method to subjectively determine a double lane-change which is one part of the vehicle dynamics and road-holding ability of passenger cars. It is applicable to passenger cars as defined in ISO 3833. It is also applicable to light commercial vehicles up to a gross vehicle mass of 3,5 t.

Passenger cars — Test track for a severe lane-change manoeuvre — Part 1: Double lane-change

ICS
43.180
CCS
发布
2022-05-12
实施

What is ISO 14229-3 - UDS on CAN implementation in road vehicles about? Diagnostic systems are developed so that the product development teams, software/hardware testing teams, and after-sales teams can detect faults in a vehicle by connecting their diagnostic tester tools to the electronic control units (ECUs) in the vehicle. ISO 14229 discusses road vehicles and unified diagnostic services (UDS) with a focus on unified diagnostic services on CAN implementation. ISO 14229-3 is the third part of the ISO 14229 multi-series on road vehicles and unified diagnostic services that specifies: Additional requirements specific to the implementation of UDS on the CAN network, and Specific restrictions in the implementation of UDS on the CAN network. UDSonCAN references ISO 14229-1 and ISO 14229-2 and specifies implementation requirements of the diagnostic services to be used for diagnostic communication on CAN. Who is ISO 14229-3 - UDS on CAN implementation in road vehicles for ? ISO 14229-3 on UDS on CAN implementation in road vehicles is useful for: Road vehicle engineers Manufacturers of road vehicl...

Road vehicles. Unified diagnostic services (UDS) - Unified diagnostic services on CAN implementation (UDSonCAN)

ICS
43.180
CCS
发布
2022-04-30
实施
2022-04-30

This document specifies an application profile for the implementation of unified diagnostic services (UDS) Internet Protocol (IP) in road vehicles (UDSonIP). UDSonIP references ISO 14229-1 and ISO 14229-2 and specifies implementation requirements of the diagnostic services to be used for diagnostic communication on Internet Protocol. This document includes — additional requirements specific to the implementation of UDS on the Ethernet network, and — specific restrictions in the implementation of UDS on the Ethernet network.

Road vehicles — Unified diagnostic services (UDS) — Part 5: Unified diagnostic services on Internet Protocol implementation (UDSonIP)

ICS
43.180
CCS
发布
2022-04-25
实施

This document specifies an application profile for the implementation of unified diagnostic services (UDS) local interconnect network (LIN) in road vehicles (UDSonLIN). UDSonLIN references ISO 14229-1 and ISO 14229-2 and specifies implementation requirements of the diagnostic services to be used for diagnostic communication on Local Interconnect Network. This document includes: — additional requirements specific to the implementation of UDS on local interconnect network; and — specific restrictions in the implementation of UDS on local interconnect network.

Road vehicles — Unified diagnostic services (UDS) — Part 7: UDS on local interconnect network (UDSonLIN)

ICS
43.180
CCS
发布
2022-04-25
实施

1   Scope This document specifies general requirements and constraints applicable to a remote diagnostic process , the use cases and scenarios to support the implementation of a remote diagnostic process using a standardized interface of the ExVe. It concerns: — the road vehicles with four or more wheels designed and constructed primarily for the carriage of persons that are defined as Category 1 vehicles in the United Nations Special Resolution No.1 in TRANS/WP.29/1045, as last amended on 19 June 2012, and — the road vehicle with four or more wheels designed and constructed primarily for the carriage of goods that are defined as Category 2 vehicles in the United Nations Special Resolution No.1 in TRANS/WP.29/1045, as last amended on 19 June 2012, where these road vehicles are still in accordance with the specifications of the vehicle manufacturer . This document does not define the interfaces provided by the ExVe nor the internal implementation inside the ExVe. Processes like repair, prognostics , monitoring, configuration, re-programming and variant coding are not part of this document. The prerequisites (e.g. authentication and authorization) for all use cases are not covered within this document. A possible specification of the required content for the implementati...

Road vehicles. Information for remote diagnostic support. General requirements, definitions and use cases

ICS
43.180
CCS
发布
2022-03-31
实施
2022-03-31

本文件规定了液压式汽车举升机的术语和定义、分类及型号、基本要求、技术要求、试验方法、检验规则、标志、包装、运输和储存以及质量承诺。 本文件适用于额定举升质量不大于20 000 kg的液压式汽车举升机(以下简称举升机)。

Hydraulic automotive lift

ICS
43.180
CCS
C343
发布
2022-03-28
实施
2022-04-08

This document specifies an application profile for the implementation of unified diagnostic services (UDS) on controller area network (CAN) in road vehicles. UDSonCAN references ISO 14229-1 and ISO 14229-2 and specifies implementation requirements of the diagnostic services to be used for diagnostic communication on CAN. This document specifies — additional requirements specific to the implementation of UDS on the CAN network, and; — specific restrictions in the implementation of UDS on the CAN network.

Road vehicles — Unified diagnostic services (UDS) — Part 3: Unified diagnostic services on CAN implementation (UDSonCAN)

ICS
43.180
CCS
发布
2022-03-08
实施

本文件规定了汽车域控制器(DCU)自动化测试线(以下简称“测试线”)的术语和定义、缩略语和检测方法。

Testing method for automatic testing line of vehicle domain control unit

ICS
43.180
CCS
M732
发布
2022-02-08
实施
2022-02-08

本文件规定了汽车域控制器(DCU)自动化测试线(以下简称“测试线”)接口的术语和定义、缩略语、要求。

Technical interface specifications for automatic testing line of vehicle domain control unit

ICS
43.180
CCS
M732
发布
2022-02-08
实施
2022-02-08

本文件规定了汽车域控制器(DCU)自动化测试线(以下简称“测试线”)的术语和定义、缩略语、构成与分类、要求。

General requirements for automatic testing line of vehicle domain control unit

ICS
43.180
CCS
M732
发布
2022-02-08
实施
2022-02-08

What is ISO 14229-2 about?   ISO 14229-2 is the second part of multiple series that specifies common session layer services and requirements to provide independence between unified diagnostic services ( ISO 14229-1 ) and all transport protocols and network layer services (e.g., ISO 13400-2 DoIP, ISO 15765-2 DoCAN, ISO 10681-2 communication on FlexRay, ISO 14230- 2 DoK-Line, and ISO 20794-3 CXPI).

Road vehicles. Unified diagnostic services (UDS). Session layer services

ICS
43.180
CCS
发布
2021-12-31
实施
2021-12-31

Road vehicles — Injury risk curves for the THOR dummy

ICS
43.180
CCS
发布
2021-12-17
实施

This standard contains technical safety requirements for the design, equipment and testing of brushless vehicle washing systems and vehicle washing systems with brushes for, indoor and outdoor operation e. g. roll-over vehicle washing systems, vehicle washing tunnels, manually mo

Safety requirements - Vehicle cleaning equipment; German version EN 17281:2021

ICS
43.180
CCS
发布
2021-12-00
实施

What is BS EN 17003 about?    A road vehicle's ability to brake effectively and efficiently is critical to the safe operation of the vehicle on roads. A roller brake tester is a method of allowing the assessment of the braking system of a vehicle, whilst the vehicle itself is in a static condition. They play a vital role in testing the brake functionality of vehicles and so need to be safe for use themselves.  BS EN 17003  specifies safety requirements for roller brake testers for road vehicles of more than 3,4 tons GVW.  T his safety standard applies to roller brake testers (brake test benches) that are designed for roadworthiness tests on categories M2, M3, N2, N3, O3, and O4 vehicles (as defined in Regulation (EU) 2018/858) and that might be also used to test M1, N1 categories.   Notes-  BS EN 17003 doesn’t cover mobile roller or plate brake testers.  BS EN 17003  covers fixed-bed roller brake testers with or without inspection pits and whose chassis are inside or outside the building.

Road vehicles. Roller brake testers for vehicles of more than 3,5 tons GVW. Safety requirements

ICS
43.180
CCS
发布
2021-11-30
实施
2021-11-30

Road vehicles — Information for remote diagnostic support — General requirements, definitions and use cases — Amendment 1

ICS
43.180
CCS
发布
2021-11-22
实施



Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号