G72 表面活性剂基础标准与通用方法 标准查询与下载

ASTM D1570-95 脂肪烷基硫酸盐的取样与化学分析的标准试验方法

1.1 These test methods cover the sampling and chemical analysis of paste, powder, or liquid detergent fatty alkyl sulfates. 1.2 The procedures for sampling and analysis appear in the following order: Sections Sampling: Powders and Flakes Packed in Cans or Cartons 4 Powders and Flakes in Bulk 5 Liquids 6 Pastes 7 Preparation of Sample 8 Moisture by the Distillation Test Method 11 to 14 pH 15 Alkalinity 16 to 19 Alcohol-Soluble Matter 20 to 22 Alcohol-Insoluble Matter 23 to 24 Unsulfated Material 25 to 28 Combined Alcohols 29 to 32 Ester SO3: Method A. Titration Test Method 36 to 37 Ester SO3: Method B. Gravimetric Test Method 38 to 39 Sodium Sulfate 40 to 43 Chlorides Calculated as Sodium Chloride (NaCl) 44 to 47 1.3 The values stated in either inch-pound or SI units are to be regarded separately as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Material Safety Data Sheets are available for reagents and materials. Review them for hazards prior to usage.

Standard Test Methods for Sampling and Chemical Analysis of Fatty Alkyl Sulfates

ANSI/ASTM D4494:1995 检测干洗级全氯乙烯残留气味的方法

This test method covers the detection of a residual odor in drycleaning-grade perchloroethylene. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 7.

Test Method for Detecting Residual Odor of Drycleaning Grade Perchloroethylene

ASTM F1021-95(2013) 商用洗碗碟机和洗玻璃器皿机用加料器, 洗涤剂, 漂清剂和消毒剂的标准规范

1.1 This specification covers detergent feeders, rinse additive feeders, and sanitizing agent feeders intended to automatically maintain the concentration of additives in the wash, recirculated rinse, or non-recirculated rinse water of commercial spray-type dishwashing and glasswashing machines. 1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

Standard Specification for Feeders, Detergent, Rinse Agent, and Sanitizing Agent for Commercial Dishwashing and Glasswashing Machines

NF T73-262:1994 表面活性剂.洗涤剂.酸性条件下可水解的和不可水解的阴离子活性物质的测定

Surface active agents. Detergents. Determination of acionic-active matter hydrolyzable and non-hydrolyzable under acid conditions.

NF T73-321:1994 表面活性剂.洗涤剂,阳离子活性物含量的测定.第2部分:低分子量(200-500)的阳离子活性物质

Surface active agents. Detergents. Determination of cationic-active matter content. Part 2 : cationic-active matter of low molecular mass (between 200 and 500).

NF T73-320:1994 表面活性剂.洗涤剂.阳离子活性物质含量的测定.第1部分:高分子量物质阳离子活性物质

Surface active agents. Detergents. Determination of cationic-active matter content. Part 1 : high-molecular-mass cationic-active matter.

JIS K 2395:1994 汽车燃料系统的水溶剂

この規格は，自動車のガソリンタンク，軽油タンクなどにたまる水分を燃料中に溶解させるために用いる水溶解剤(以下，水抜剤という。)について規定する。

Water solubilizer in fuel system for automobiles

HG/T 2575-1994 表面活性剂 润湿力的测定 浸没法

本标准规定了一种用原棉布圆片浸没法测定表面活性剂溶液润湿力的方法。 本标准适用于在中性、弱酸性或弱碱性溶液中用作纺织润湿剂的所有表面活性剂（不论其离子特性如何），不适用于丝光助剂（强碱性溶液）或碳化助剂（强酸性溶液）。

Determination of wetting power of surfactants by immersion method

BS 6829 Sec.1.6:1991 表面活性剂分析(原料).第1部分:一般方法.第6节:水可溶性的测定方法

Analysis of surface active agents (raw materials). General methods. Method for determination of solubility in water

BS 6829-1.6:1991 表面活性剂（原料）分析 一般方法 水中溶解度的测定方法

Applicable to pure anionic surface active agents.

Analysis of surface active agents (raw materials). General methods. Method for determination of solubility in water

BS EN ISO 862:1991 表面活性剂术语词汇

Terms relating to product designation, special properties, manufacture and applications. Includes alphabetical indexes.

Glossary of terms for surface active agents

ISO 1065:1991 由环氧乙烷制得的非离子表面活性剂及混合非离子表面活性剂 浊点的测定

Specifies five methods of measurement. Methods A, B and C are applicable to agents derived by condensation with a lipophilic compound without oxypropylene groups. Methods D and E should be used only after agreement between the parties concerned. This second edition cancels and replaces the first edition (1975).

Non-ionic surface-active agents obtained from ethylene oxide and mixed non-ionic surface-active agents; determination of cloud point

BS 6829-0:1991 表面活性剂(原料)的分析.第0部分:一般导言

Describes the structure of BS 6829 and gives guidance on its use.

Analysis of surface active agents (raw materials) - General introduction

ASTM D800-91(1997) 工业用金属洗涤混合剂化学分析的标准试验方法

1.1 These test methods describe the procedures for the chemical analysis of industrial metal cleaning compositions in solid, paste, or liquid form. These cleaning compositions may contain caustic alkalies, silicates, phosphates, chromates, carbonates, bicarbonates, borates, sulfates, sulfites, nitrates, chlorides, soaps, rosin, sulfonated wetting agents, anti-foaming agents, organic bases, organic solvents, organic coupling agents, and sometimes inorganic acid salts or organic acids. Occasionally, such cleaning compositions may contain sulfonated oils; in such cases, reference should be made to Method D500. The examination under a low power microscope or magnifying glass, supplemented by a few qualitative tests, will often indicate the number of components and their identity. 1.2 The analytical methods appear in the following order: Section Preparation of Sample 4 Total Alkalinity as Na2O 5 to 7 Total Fatty Acids (and Rosin) 8 and 9 Na2O Na[inf]2[r]O 5 to 7 Total Fatty Acids (and Rosin) 8 and 9 Na[inf]2[r]O Combined with Fatty Acids (and Rosin) 10 and 11 Anhydrous Soap 12 Rosin (McNicoll Test Method): Qualitative 13 and 14 Quantitative 15 to 18 Total Silica Calculated as SiO[inf]2[r] 19 to 22 Phosphates: Qualitative 23 and 24 Quantitative 25 to 32 Combined Sodium and Potassium Oxides 33 to 36 Chlorides 37 to 39 Sulfates 40 to 42 Water Distillation Test Method 43 to 46 Carbon Dioxide by Evolution-Absorption Test Method 47 to 51 Loss at 105[deg]C 52 and 53 Total Matter Insoluble in Alcohol 54 to 56 Free Alkali 57 to 59 Synthetic Detergent or Wetting Agent 60 and 61 Volatile Hydrocarbons 62 to 66 Loss on Ignition 67 and 68 Report 69 and 70 1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.> Material Safety Data Sheets are available for reagents and materials. Review them for hazards prior to usage.

Standard Test Methods of Chemical Analysis of Industrial Metal Cleaning Compositions

ISO 2871-2:1990 表面活性剂 洗涤剂 阳离子活性物含量的测定 第2部分:低分子质量(200～500)阳离子活性物

The method is also suitable for other cationic-active materials. Not applicable if anionic and/or amphoteric surface active agents are present. The sample is titrated in a two-phase (aqueous chloroform) system against a standard anionic surface active agent in the presence of an indicator consisting of mixed anionic and cationic dyes. The cationic surface active agent present in the sample initially reacts with the anionic dye to form a salt which dissolves in the chloroform, imparting a blue colour to this layer. During the titration, the anionic surface active agent displaces the anionic dye and, at the end point, forms a salt with the cationic dye, imparting a greyish-pink colour to the chloroform layer.

Surface active agents; detergents; determination of cationic-active matter content; part 2: cationic active matter of low molecular mass (between 200 and 500)

ISO 8022:1990 表面活性剂 用浸没法测定润湿力

A cotton disc of known nature and characteristics, held in a grip, is immersed in a solution of surface active agent of known concentration. After displacement of air an penetration of the solution into the cloth, the cotton disc starts to sink. The wetting time is determined by measurement the interval between the moment of immersion of the cotton disc and the moment when it begins to sink. The wetting time is determined of two standard solutions and for each of five different concentrations and then of the surface active agent solution under test for five different concentrations. The three curves "wetting time / concentration" are plotted and compared.

Surface active agents; determination of wetting power by immersion

JIS K 3211:1990 表面活性剂的技术术语

この規格は，界面活性剤工業において用いられる主な用語及びその定義について規定する。

Technical terms for surface active agents

BS 6829-5.1:1990 表面活性剂（原料）分析 乙氧基化醇和烷基酚硫酸盐 总活性物质含量的测定方法

Boiling under reflux with ethanol, filtration, evaporation of the filtrate and weighing of the residue. Correction by determining any sodium chloride present by titration with silver nitrate solution.

Analysis of surface active agents (raw materials). Ethoxylated alcohol and alkylphenol sulphates. Method for determination of total active matter content

BS 6829-4.3:1990 表面活性剂（原料）分析 环氧乙烷加合物 氧乙烯基团的测定方法

Hydrolysis followed by iodometric determination. Applicable to adducts of ethylene oxide with primary saturated fatty alcohols, oleyl alcohol, saturated fatty acids or alkylphenols.

Analysis of surface active agents (raw materials). Ethylene oxide adducts. Method for determination of oxyethylene groups

BS 6829 Sec.4.3:1990 表面活性剂(原料)的分析.第4部分:乙基氧化加成化合物.第3节:氧化乙烯基的测定方法

Analysis of surface active agents (raw materials). Ethylene oxide adducts. Method for determination of oxyethylene groups