G75 催化剂 标准查询与下载



共找到 125 条与 催化剂 相关的标准,共 9

Special catalyst for catalytic cracking process to increase isoparaffin production and increase propylene production

ICS
71.100.99
CCS
G75
发布
2018-10-22
实施
2019-04-01

Catalyst for gas phase hydrogenation of octenal to 2-ethylhexanol

ICS
71.100.99
CCS
G75
发布
2018-10-22
实施
2019-04-01

Alkylation catalyst

ICS
71.100.99
CCS
G75
发布
2018-04-30
实施
2018-09-01

Nickel-based gas phase benzene hydrogenation catalyst

ICS
71.100.99
CCS
G75
发布
2017-11-07
实施
2018-04-01

Catalyst for gas-phase hydrogenation of butyraldehyde to butanol and nickel-based catalyst for gas-phase hydrogenation of benzene (2017)

ICS
CCS
G75
发布
2017-11-07
实施
2018-04-01

Catalyst for gas phase hydrogenation of butyraldehyde to butanol

ICS
71.100.99
CCS
G75
发布
2017-11-07
实施
2018-04-01

This standard describes a method for assessing the performance of photocatalytic inorganic materials contained in cement mortars and/or limes or ceramic-based matrices, paints or materials deposited as thin films or coatings on a variety of substrates for the photocatalytic abatement of nitric oxide in the gas phase. This method is not suitable for the assessment of samples to be applied with flow perpendicular to the surface or flow permeating the surface itself as polymeric and paper filters, honeycomb structures and suchlike. The performance for the photocatalytic sample under test is evaluated by measuring the degradation rate of nitric oxide (NO) using the method described herein. The photocatalytic abatement rate is calculated from the observed rate by eliminating the effects of mass transfer. The intrinsic photocatalytic abatement rate is an intrinsic property of the material tested and makes it possible to distinguish the photocatalytic activities of various products with an absolute scale defined with physical and engineering meaning. For the measurements and calculations described in this standard the concentration of nitrogen oxides (NOx) is defined as the stoichiometric sum of nitric oxide (NO) and nitrogen dioxide (NO2). Safety statement Persons using this document should be familiar with the normal laboratory practice, if applicable. This document cannot address all of the safety problems, if any, associated with its use. It is the responsibility of the user to establish appropriate safety and health practices and to ensure compliance with any regulatory conditions. Environmental statement It is understood that some of the material permitted in this standard may have negative environmental impact. As technological advantages lead to better alternatives for these materials, they will be eliminated from this standard to the extent possible. At the end of the test, the user of the standard will take care to carry out an appropriate disposal of the wastes, according to local regulation.

Photocatalysis - Continuous flow test methods - Part 1: Determination of the degradation of nitric oxide (NO) in the air by photocatalytic materials

ICS
25.220.20
CCS
G75
发布
2016-12
实施

A common language for standards, disclosed to a wide audience and referring only to the operational protocols and to their outcomes, is needed both for a consistent set of standards and the connection with the scientific literature. This glossary will take into account existing glossary of terms used in photocatalysis and photochemistry. Because in photocatalysis numerous properties are difficult to be evaluated, it is strongly recommended in standard norms to avoid reporting properties depending on number of actives sites, the mechanisms of adsorption or kinetic mechanisms of photocatalytic reactions. For the same reason instead of the quantum yield and related quantities it is easier to report the photonic efficiency. Most of the definitions reported in this Technical Specification are a sub-set of the IUPAC definitions in photocatalysis and radiocatalysis. Some other definitions, in particular for the photocatalytic rate and reactors are taken from a dedicated work. The use and many technical specifications on the physical values suggested for irradiation conditions in the standards are reported in a separate Technical Specification. The arrangement of entries is alphabetical, and the criterion adopted by the IUPAC has been followed for the typeface used: italicized words in a definition or following it indicate a cross-reference in the Glossary.

Photocatalysis - Glossary of terms

ICS
01.040.25;25.220.01
CCS
G75
发布
2016-11
实施

Carbon monoxide sulfur tolerant shift catalyst

ICS
71.100.99
CCS
G75
发布
2016-10-22
实施
2017-04-01

本标准规定了联产甲醇催化剂(简称“联醇催化剂”)和高压甲醇合成催化剂(简称“高压甲醉催化剂”)、中低压甲醇合成催化剂(简称“中低压甲醇催化剂”)的要求,采样,试验方法,检验规则以及标志、包装、储存和运输。 本标准适用于以煤、油、天然气(包括油田气)、焦炉气、乙烯尾气、乙炔尾气等为原料生产甲醇的甲醇合成催化剂。

Methanol synthesis catalysts

ICS
71.100.99
CCS
G75
发布
2016-10-22
实施
2017-04-01

本标准规定了硫酸生产用铯催化剂的要求,试验方法,检验规则,标志、包装、贮存和运输。 本标准适用于硫酸生产过程中将二氧化硫氧化成三氧化硫的含铯催化剂。

Cesium catalyst of sulfuric acid production use

ICS
71.100.99
CCS
G75
发布
2015-07-29
实施
2016-01-01

本标准规定了氨氧化制硝酸用高钯催化剂的要求,试验方法,检验规则以及标志、包装和运输。 本标准适用于钯质量分数在25 %~35 %的氨氧化制硝酸用催化剂。

High palladium catalyst for ammonia oxidation in nitric acid production

ICS
71.100.99
CCS
G75
发布
2015-07-29
实施
2016-01-01

本标准规定了常温氧硫化碳水解催化剂中氧化钾(KO)、氧化铝(AlO)、氧化钠(NaO)以及烧失量质量分数的分析方法。 本标准适用于以氧化铝为载体、钾为主要活性组分的常温氧硫化碳水解催化剂。

Analytical method of chemical composition for carbonyl sulfide hydrolyzed catalysts at room temperature

ICS
71.100.99
CCS
G75
发布
2015-07-29
实施
2016-01-01

本标准规定了甲醇制低碳烯烃催化剂的要求,试验方法,检验规则,标志、包装、贮存和运输。 本标准适用于甲醇制低碳烯烃(MTO)工艺流程中的甲醇制低碳烯烃用固体催化剂。

Methanol to light olefins catalysts

ICS
71.100.99
CCS
G75
发布
2015-07-29
实施
2016-01-01

本标准规定了费托合成沉淀铁催化剂的要求,试验方法,检验规则以及标志、包装、储存和运输。本标准适用于氢气和一氧化碳反应合成烃类用微球费托合成沉淀铁催化剂。

Precipitated iron catalyst for Fischer-Tropsch synthesis

ICS
71.100.99
CCS
G75
发布
2014-10-29
实施
2015-04-01

本标准规定了氨氧化制硝酸用铂催化剂的要求,试验方法,检验规则以及标志、包装、贮存和运输。本标准适用于氨氧化制硝酸、氢氰酸以及己内酰胺用网状铂催化剂。

The platinum catalyst Oxidizing ammonia into nitric acid

ICS
71.100.99
CCS
G75
发布
2014-10-29
实施
2015-04-01

Technical Requirements for Selective Catalytic Reduction (SCR) Denitrification Catalysts in Shandong Province

ICS
70.100.01
CCS
G75
发布
2014-09-25
实施
2014-11-01

This Technical Specification prescribes the conditions for irradiating photocatalytic surfaces in order to perform photocatalytic efficiency tests. In addition, the measurement and documentation of these irradiation conditions with respect to the spectral distribution, irradiance and homogeneity are given.

Photocatalysis - Irradiation conditions for testing photocatalytic properties of semiconducting materials and the measurement of these conditions

ICS
25.220.20
CCS
G75
发布
2014-03
实施

本标准规定了 Z102、Z107、Z108、Z109-1Y、Z109-2Y、Z110Y、Z111型天然气一段转化催化剂的要求,试验方法,检验规则及标志、包装、储存、运输。本标准适用于合成氨、甲醇及制氢工业中以天然气、水蒸气为原料制取合成气(CO+H)和氢气装置使用的Z102、Z107、Z108、Z109-1Y、Z109-2Y、Z110Y、Z111型天然气一段转化催化剂及其同类型产品。

The natural gas catalyst for primary reforming

ICS
71.100.99
CCS
G75
发布
2013-10-17
实施
2014-03-01

本标准规定了 Z203、Z204、Z206型天然气二段转化催化剂的要求,试验方法,检验规则及标志、包装、储存、运输。本标准适用于合成氨厂二段转化炉中天然气进一步转化制取氢气和类似工艺过程制氢的其他转化装置使用的Z203、Z204、Z206型天然气二段转化催化剂及其同类型产品。

The natural gas catalyst for secondary reforming

ICS
71.100.99
CCS
G75
发布
2013-10-17
实施
2014-03-01



Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号