K49 避雷器 标准查询与下载

BS EN 62561-4:2011 防雷保护系统部件(LPSC).导线紧固件要求

Lightning protection system components (LPSC). Requirements for conductor fasteners

BS EN 50536:2011+A1:2012 防雷保护.雷暴警告系统

Protection against lightning. Thunderstorm warning systems

BS EN 62305-1:2011 雷电防护.通则

This part of IEC 62305 provides general principles to be followed for protection of structures against lightning, including their installations and contents, as well as persons. The following cases are outside the scope of this standard: – railway systems; – vehicles, ships, aircraft, offshore installations; – underground high pressure pipelines; - pipe, power and telecommunication lines placed outside the structure. NOTE These systems usually fall under special regulations produced by various specialized authorities.

Protection against lightning. General principles

BS EN 62305-3:2011 闪电防护.建筑物的物理损坏和生命危险

This part of EN 62305 provides the requirements for protection of a structure against physica l damage by means of a lightning protection system (LPS), and for protection against injury to living beings due to touch and step voltages in the vicinity of an LPS (see -1 ). This standard is applicable to: a) design, installation, inspection and maintenance of an LPS for structures without limitation of their height, b) establishment of measures for protection against injury to living beings due to touch and step voltages.

Protection against lightning. Physical damage to structures and life hazard

BS EN 62305-4:2011 雷电防护.构筑物内的电气和电子系统

This part of IEC 62305 provides information for the design, installation, inspection, maintenance and testing of electrical and electronic system protection (SPM) to reduce the risk of permanent failures due to lightning electromagnetic impulse (LEMP) within a structure. This standard does not cover protection against electromagnetic interference due to lightning, which may cause malfunctioning of internal systems. However, the information reported in Annex A can also be used to evaluate such disturbances. Protection measures against electromagnetic interference are covered in IEC 60364-4-44 and in the IEC 61000 series. This standard provides guidelines for cooperation between the designer of the electrical and electronic system, and the designer of the protection measures, in an attempt to achieve optimum protection effectiveness. This standard does not deal with detailed design of the electrical and electronic systems themselves.

Protection against lightning. Electrical and electronic systems within structures

BS EN 60099-8:2011 避雷器.用于1 kV以上交流系统架空输配电线路的设有外间隙(EGLA)的金属氧化物避雷器

This part of IEC 60099 covers metal-oxide surge arresters with external series gap (externally gapped line arresters (EGLA) that are applied on overhead transmission and distribution lines, only to protect insulator assemblies from lightning-caused flashovers. This standard defines surge arresters to protect the insulator assembly from lightning-caused overvoltages only. Therefore, and since the metal-oxide resistors are not permanently connected to the line, the following items are not considered for this standard: • switching impulse sparkover voltage; • residual voltage at steep current and switching current impulse; • thermal stability; • long-duration current impulse withstand duty; • power-frequency voltage versus time characteristics of an arrester; • disconnector test; • aging duties by power-frequency voltage. Considering the particular design concept and the special application on overhead transmission and distribution lines, some unique requirements and tests are introduced, such as the verification test for coordination between insulator withstand and EGLA protective level, the follow current interrupting test, mechanical load tests, etc. Designs with the EGLA's external series gap installed in parallel to an insulator are not covered by this standard.

Surge arresters. Metal-oxide surge arresters with external series gap (EGLA) for overhead transmission and distribution lines of a.c. systems above 1 kV

IEC 62561-5:2011 雷电防护系统组件(LPSC) 第5部分 接地极检测箱和接地电极密封要求

This Part 5 of IEC 62561 specifies the requirements and tests for ?C earth electrode inspection housings (earth pit)@ ?C earth electrode seals. Lightning protection system components (LPSC) may also be suitable for use in hazardous atmospheres. Regard should then be taken of the extra requirements necessary for the components to be installed in such conditions. NOTE Different requirements and test procedures are given in EN 124 and EN-1253-1.

Lightning protection system components (LPSC) - Part 5: Requirements for earth electrode inspection housings and earth electrode seals

IEC 62561-6:2011 雷电防护系统组件(LPSC).第6部分:雷击计数器(LSC)要求

This Part 6 of IEC 62561 specifies the requirements and tests for devices intended to count the number of lightning strike pulses flowing in a conductor. This conductor may be part of a lightning protection system (LPS) or connected to an SPD installation (or other conductors which are not intended to conduct a significant portion of lightning currents). NOTE Lightning strike counters may also be suitable for use in hazardous atmospheres. Regard should then be taken of the extra requirements necessary for the components to be installed in such conditions.

Lightning protection system components (LPSC) - Part 6: Requirements for lightning strike counters (LSC)

KS C IEC 60099-7:2011 避雷器.第7部分:IEC出版物KS C 60099-1、60099-4、60099-6、61643-1、61643-12、61643-21、61643-311、61643-321、61643-331及61643-341的术语和定义词汇编

이 문서는 발행일 현재 IEC TC 37(서지 피뢰기), IEC SC 37A(저압 서지 보

Surge arresters－Part 7：Glossary of terms and definitions from KS C IEC publications 60099－1, 60099－4, 60099－6, 61643－1,61643－12, 61643－21, 61643－311, 61643－321, 61643－331,and 61643－341

KS C IEC 61663-1:2011 避雷装置.电信线路.第1部分:光纤安装 

이 표준은 광섬유 설비에서 통신 회선의 뇌 보호에 관한 사항을 다루고 있다.이 표준

Lightning protection-Telecommunication lines-Part 1:Fibre optic installations

KS C 4616-2011 用于交流系统的无隙金属氧化物避雷器

이 표준은 교류 전력 회로의 서지 전압을 제한하도록 설계된 방전 갭이 없는 비직선 금속 산

Metal-oxide surge arresters without gaps for a.c. systems

KS C 4610-2011 6.6kV配电室用避雷器

이 표준은 서지 보호 소자를 사용하여 교류 전력 회로의 전압 서지를 제한하고 속류를 차단시

Lightning arresters for 6.6 kV cubicle type unit substation

KS C 4808-2011 配电线路无隙氧化聚合金属避雷器

이 표준은 36 kV 이하의 교류 전력 회로의 서지 전압을 제한하도록 설계된 방전 갭이 없

Polymer-housed metal-oxide surge arresters without gaps for distribution line

KS C IEC 60099-3:2011 避雷器.第3部分:避雷器的人工污秽试验

이 문서는 비선형 저항성 피뢰기(밸브형)(non-linear resistor type su

Surge arresters－Part 3：Artificial pollution testing of surge arresters

KS C IEC 61663-2:2011 避雷装置.电信线路.第2部分:金属导线

이 표준은 외부에 설치된 금속 도체를 사용한 통신선(예를 들면, 네트워크에 연결, 빌딩 사

Lightning protection-Telecommunication lines-Part 2:Lines using metallic conductors

NF C17-153-4:2011 避雷装备零件(LPSC).第4部分:导体紧固件要求.

Lightning protection system components (LPSC) - Part 4 : requirements for conductor fasteners.

ANSI/IEEE 1692:2011 来自闪电效果的通讯设施防护指南

Guide for the Protection of Communication Installations from Lightning Effects

IEC 62305-4:2010 雷电防护.第4部分:建筑物中电气和电子系统

This part of IEC 62305 provides information for the design, installation, inspection, maintenance and testing of electrical and electronic system protection (SPM) to reduce the risk of permanent failures due to lightning electromagnetic impulse (LEMP) within a structure. This standard does not cover protection against electromagnetic interference due to lightning, which may cause malfunctioning of internal systems. However, the information reported in Annex A can also be used to evaluate such disturbances. Protection measures against electromagnetic interference are covered in IEC 60364-4-44 and in the IEC 61000 series. This standard provides guidelines for cooperation between the designer of the electrical and electronic system, and the designer of the protection measures, in an attempt to achieve optimum protection effectiveness. This standard does not deal with detailed design of the electrical and electronic systems themselves.

Protection against lightning - Part 4: Electrical and electronic systems within structures

IEC 62305-2:2010 雷电防护.第2部分:风险管理

This part of IEC 62305 is applicable to risk assessment for a structure due to lightning flashes to earth. Its purpose is to provide a procedure for the evaluation of such a risk. Once an upper tolerable limit for the risk has been selected, this procedure allows the selection of appropriate protection measures to be adopted to reduce the risk to or below the tolerable limit.

Protection against lightning - Part 2: Risk management

IEC 62305-3:2010 雷电防护.第3部分:建筑物的物理损害和生命危险

This part of IEC 62305 provides the requirements for protection of a structure against physical damage by means of a lightning protection system (LPS), and for protection against injury to living beings due to touch and step voltages in the vicinity of an LPS (see IEC 62305-1). This standard is applicable to: a) design, installation, inspection and maintenance of an LPS for structures without limitation of their height, b) establishment of measures for protection against injury to living beings due to touch and step voltages. NOTE 1 Specific requirements for an LPS in structures dangerous to their surroundings due to the risk of explosion are under consideration. Additional information is provided in Annex D for use in the interim. NOTE 2 This part of IEC 62305 is not intended to provide protection against failures of electrical and electronic systems due to overvoltages. Specific requirements for such cases are provided in IEC 62305-4. NOTE 3 Specific requirements for protection against lightning of wind turbines are reported in IEC 61400-24.

Protection against lightning - Part 3: Physical damage to structure and life hazard