L86 通用电子测量仪器设备及系统 标准查询与下载

JJF 1165-2007 信纳表校准规范

本规范适用于音频调制信号频率为1kHz、信纳测量范围为0dB～20dB的信纳表的校准。

Calibration Specification for SINAD Meters

JJF 1167-2007 杂音计校准规范

本规范适用于杂音计（也称杂音电压表、杂音测试器）的校准。

Calibration Specification for Psophometers

JJF 1173-2007 测量接收机校准规范

本规范适用于新制造、新购置、使用中和修理后的150kHz～265GHz频率范围测量接收机的校准。

Calibration Specification of Measuring Receivers

BS EN 55016-1-3:2006 无线电干扰和抗扰测量仪和方法用规范.第1-3部分:无线电干扰和抗扰测量仪.辅助设备.干扰功率

This part of CISPR 16 is designated a basic standard, which specifies the characteristics and calibration of the absorbing clamp for the measurement of radio disturbance power in the frequency range 30 MHz to 1 GHz.

Specification for radio disturbance and immunity measuring apparatus and methods - Part 1-3: Radio disturbance and immunity measuring apparatus - Ancillary equipment - Disturbance power

AIMC 0003-2006 射频识别读写器通用技术规范.频率低于135kHz

本标准规定了频率低于135kHz的读写器的技术指标。 本标准适用于单品识别，也可参照ISO/IEC 18000-2国际标准使用。

General Technical Specifications for Radio Frequency Identification Readers. Frequency lower than 135kHz

AIMC 0005-2006 射频识别读写器通用技术规范.频率为2.45 GHz

本标准规定了频率为2.45 GHz的读写器的技术指标。 本标准适用于单品识别，也可参照ISO/IEC 18000-4国际标准使用。

General Technical Specifications for Radio Frequency Identification Readers. Frequency at 2.45 GHz

AIMC 0007-2006 射频识别读写器通用技术规范.频率为433 MHz

本标准规定了频率为433 MHz的读写器的技术指标。 本标准适用于单品识别，也可参照ISO/IEC 18000-7国际标准使用。

General Technical specifications for Radio Frequency Identification Readers. Frequency at 433MHz

AIMC 0004-2006 射频识别读写器通用技术规范.频率为13.56MHz

本标准规定了频率为13.56 MHz的读写器的技术指标。 本标准适用于单品识别，也可参照ISO/IEC 18000-3，ISO 15693国际标准使用。

General Technical Specifications for Radio Frequency Identification Readers. Frequency at 13.56 MHz

AIMC 0006-2006 射频识别读写器通用技术规范.频率为860～960 MHz

本标准规定了频率为860～960 MHz的读写器的技术指标。 本标准适用于单品识别，也可参照ISO/IEC 18000-6国际标准使用。

General Technical Specifications for Radio Frequency Identification Readers. Frequency at 860～960 MHz

JJF 1160-2006 中小规模数字集成电路测试设备校准规范

本规范适用于测试时钟频率小于10MHz、没有时间测量单元的中小规模数字集成电路测试设备校准。

Calibration Specification of Small & Medium Scale Digital Integrated Circuit Testing System

DIN EN 55016-2-4:2005 无线电干扰和抗扰测量仪器和方法规范.第2-4部分:干扰和抗扰测量方法.干扰测量

Specification for radio disturbance and immunity measuring apparatus and methods - Part 2-4: Methods of measurement of disturbances and immunity - Immunity measurements (IEC/CISPR 16-2-4:2003); German version EN 55016-2-4:2004

NAVY MIL-PRF-81380 E-2005 航空燃油计量系统污染滤波器/监视器

This specification covers aviation fuel contamination filter/monitor elements and housings.

FILTER/MONITOR, CONTAMINATION, AVIATION FUEL DISPENSING SYSTEM

SANS 216-1-3:2005 无线电干扰和抗扰性测量仪器及方法规范．第1．3部分：无线电干扰和抗扰性测量仪器．辅助设备．骚扰功率

Is designated a basic standard, which specifies the characteristics and calibration of the absorbing clamp for the measurement of radio disturbance power in the frequency range 30 MHz to 1 GHz.

Specification for radio disturbance and immunity measuring apparatus and methods Part 1-3: Radio disturbance and immunity measuring apparatus - Ancillary equipment - Disturbance power

BS EN 55016-2-4:2004 无线电干扰和抗扰测量仪器和方法用规范.第2-4部分:干扰和抗扰的测量方法.抗干扰测量

This part of CISPR 16 is designated a basic standard, which specifies the methods of measurement of immunity to EMC phenomena in the frequency range 9 kHz to 18 GHz.

Specification for radio disturbance and immunity measuring apparatus and methods - Part 2-4: Methods of measurement of disturbances and immunity - Immunity measurements

BS EN 55016-2-3:2004 无线电干扰和抗扰测量仪器和方法用规范.干扰和抗扰的测量方法.辐射干扰测量

This part of CISPR 16 is designated a basic standard, which specifies the methods of measurement of radiated disturbance phenomena in the frequency range 9 kHz to 18 GHz.

Specification for radio disturbance and immunity measuring apparatus and methods - Part 2-3: Methods of measurement of disturbances and immunity - Radiated disturbance measurements

BS EN 55016-2-2:2004 无线电干扰和抗扰测量仪和方法用规范.第2-2部分:干扰和抗扰测量方法.干扰功率的测量

This part of CISPR 16 is designated a basic standard, which specifies the methods of measurement of disturbance power using the absorbing clamp in the frequency range 30 MHz to 1 000 MHz.

Specification for radio disturbance and immunity measuring apparatus and methods - Part 2-2: Methods of measurement of disturbances and immunity - Measurement of disturbance power

BS EN 55016-2-1:2004 无线电干扰和抗扰测量仪器和方法用规范.第2-1部分:干扰和抗扰的测量方法.传导干扰测量

This part of CISPR 16 is designated a basic standard, which specifies the methods of measurement of disturbance phenomena in general in the frequency range 9 kHz to 18 GHz and especially of conducted disturbance phenomena in the frequency range 9 kHz to 30 MHz.

Specification for radio disturbance and immunity measuring apparatus and methods - Part 2-1: Methods of measurement of disturbances and immunity - Conducted disturbance measurements

BS EN 55016-1-5:2004 无线电干扰和抗扰测量仪器和方法用规范.无线电干扰和抗扰测量仪器.30MHz～1000MHz的天线校准试验装置

This part of CISPR 16 is designated a basic standard which specifies the requirements for calibration test sites, used to perform antenna calibrations, as well as the test antenna characteristics, calibration site verification procedure and site compliance criteria. Further information on calibration site requirements, test antenna considerations and the theory of antennas and site attenuation is provided in informative annexes. Measurement instrumentation specifications are given in CISPR 16-1-1 and CISPR 16-1-4. Further information and background on uncertainties in general is given in CISPR 16-4-1, which may be helpful in establishing uncertainty estimates for the calibration processes of antennas.

Specification for radio disturbance and immunity measuring apparatus and methods - Radio disturbance and immunity measuring apparatus - Antenna calibration test sites for 30 MHz to 1 000 MHz

BS EN 55016-1-4:2004 无线电干扰和抗扰测量仪器和方法规范.无线电干扰和抗扰测量仪器.辅助设备.辐射干扰

This part of CISPR 16 is designated a basic standard, which specifies the characteristics and performance of equipment for the measurement of radiated disturbances in the frequency range 9 kHz to 18 GHz. Specifications for ancillary apparatus are included for: antennas and test sites, TEM cells, and reverberating chambers. The requirements of this publication shall be complied with at all frequencies and for all levels of radiated disturbances within the CISPR indicating range of the measuring equipment. Methods of measurement are covered in Part 2-3, and further information on radio disturbance is given in Part 3 of CISPR 16. Uncertainties, statistics and limit modelling are covered in Part 4 of CISPR 16.

Specification for radio disturbance and immunity measuring apparatus and methods - Radio disturbance and immunity measuring apparatus - Ancillary equipment - Radiated disturbances

BS EN 55016-1-2:2004 无线电干扰和抗扰测量仪和方法用规范.无线电干扰和抗扰测量仪.辅助设备.传导干扰

This part of CISPR 16 is designated a basic standard, which specifies the characteristics and performance of equipment for the measurement of radio disturbance voltages and currents in the frequency range 9 kHz to 1 GHz. Specifications for ancillary apparatus are included for: artificial mains networks, current and voltage probes and coupling units for current injection on cables. The requirements of this publication shall be complied with at all frequencies and for all levels of radio disturbance voltages and currents within the CISPR indicating range of the measuring equipment. Methods of measurement are covered in Part 2, and further information on radio disturbance is given in Part 3 of CISPR 16.

Specification for radio disturbance and immunity measuring apparatus and methods - Radio disturbance and immunity measuring apparatus - Ancillary equipment - Conducted disturbances