T36 电子、电气设备 标准查询与下载



共找到 1044 条与 电子、电气设备 相关的标准,共 70

Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 1: general requirements

ICS
43.040.10;43.120
CCS
T36
发布
2013-11-09
实施
2013-11-09

本标准规定了车载U盘、SD卡及AUX接口的音频播放器(以下简称“播放器”)的要求、试验方法、检测规则等。本标准适用于M、N类车辆。

Specification for audio player on board

ICS
43.040.10
CCS
T36
发布
2013-10-17
实施
2014-03-01

本标准规定了汽车座椅加热垫的术语、技术要求、检验规则、标志、包装运输、储存的要求。 本标准适用于12V或24V电系的汽车座椅用加热垫。

Performance requirement and test of heating car cushion

ICS
43.040.60
CCS
T36
发布
2013-10-17
实施
2014-03-01

本标准规定了汽车空调(HFC-134a)储液干燥器(以下简称储液干燥器)的技术要求、试验方法、检验规则、标志、包装、运输和储存。本标准适用于以HFC-134a为制冷剂、工作压力在0~2.5MPa、有效内容积小于1000mL的汽车空调储液干燥器。

Vehicle air conditioner (HFC-134a) receiver dryer

ICS
43.040.60
CCS
T36
发布
2013-10-17
实施
2014-03-01

本标准规定了汽车电动门锁装置的技术要求、试验方法、检验规则、标志、包装、运输及储存等。本标准适用沿铰链轴作旋转运动的汽车车门电动门锁装置,其它型式的电动门锁装置也可参照执行。

Electronic locks system for motor vehicles

ICS
43.040.60
CCS
T36
发布
2013-10-17
实施
2014-03-01

本标准规定了制冷剂为HFC-134a的乘用车空调系统的要求、试验方法、检验规则及标志、包装、运输和储存的要求。本标准适用于乘用车空调系统的生产、试验和检测。

Passenger vehicle air-conditioning unit

ICS
43.040.60
CCS
T36
发布
2013-10-17
实施
2014-03-01

SAE J2461 specifies the recommended practices of a Vehicle Electronics Programming Stations (VEPS) architecture.in a Win32® environment. This system specification, SAE J2461, was a revision of the requirements for Vehicle Electronics Programming Stations (VEPS) set forth in SAE J2214, Vehicle Electronics Programming Stations (VEPS) System Specification for Programming Components at OEM Assembly Plants (Cancelled Jun 2004). The J2214 standard has been cancelled indicating that it is no longer needed or relevant.

Vehicle Electronic Programming Stations (VEPS) System Specification for Win32Âę

ICS
35.240.60;43.060.50
CCS
T36
发布
2013-09-23
实施
2013-09-27

Road vehicles - Four-pole electrical connectors with pins and twist lock - Part 2: Tests and requirements; Technical Corrigendum 1

ICS
43.040.10
CCS
T36
发布
2013-09-15
实施

Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 1: General requirements; German version EN 62196-1:2012/A11:2013

ICS
43.040.10;43.120
CCS
T36
发布
2013-09
实施
2013-09-01

This SAE Standard applies to 12 V, flooded and absorptive glass mat lead acid automotive storage batteries of 200 minutes or less reserve capacity and cold crank capacity greater than 200 amperes. This life test is considered to be comprehensive in terms of battery manufacturing technology; applicable to lead-acid batteries containing wrought or cast positive grid manufacturing technology and providing a reasonable correlation for hot climate applications. This document is intended as a guide toward standard practice, but may be subject to change to keep pace with experience and technical advances.

Comprehensive Life Test for 12 V Automotive Storage Batteries

ICS
29.220.20
CCS
T36
发布
2013-08-14
实施
2018-05-11

This part of ISO 15031 gives guidelines for the protection of road vehicle modules from unauthorized intrusion through a vehicle diagnostic data link. These security measures offer vehicle manufacturers the flexibility to tailor their security to their own specific needs and do not exclude other, additional measures.

Road vehicles.Communication between vehicle and external equipment for emissions-related diagnostics.Part 7: Data link security

ICS
13.040.50;43.040.10
CCS
T36
发布
2013-07
实施

Road vehicles - Component test methods for electrical disturbances from narrowband radiated electromagnetic energy - Part 7: Direct radio frequency (RF) power injection; Amendment 1

ICS
33.100.20;43.040.10
CCS
T36
发布
2013-06-15
实施

This SAE Recommended Practice defines procedures that may be used to validate that relevant EDR output records conform with the reporting requirements specified in Part 563, Table 1 during the course of FMVSS-208, FMVSS-214 and other applicable vehicle level crash testing.

Event Data Recorder - Compliance Assessment

ICS
43.040.15
CCS
T36
发布
2013-06-13
实施

Road vehicles. Vehicle to grid communication interface. General information and use-case definition

ICS
43.040.15;43.120
CCS
T36
发布
2013-05-31
实施
2013-05-31

This SAE Information Report SAE J2836-6 establishes use cases for communication between plug-in electric vehicles and the EVSE, for wireless energy transfer as specified in SAE J2954. It addresses the requirements for communications between the on-board charging system and the Wireless EV Supply Equipment (WEVSE) in support of detection of the WEVSE, the charging process, and monitoring of the charging process. Since the communication to the charging infrastructure and the power grid for smart charging will also be communicated by the WEVSE to the EV over the wireless interface, these requirements are also covered. However, the processes and procedures are

Use Cases for Wireless Charging Communication for Plug-in Electric Vehicles

ICS
43.120
CCS
T36
发布
2013-05-03
实施

本规程适用于电子停车计时收费表、停车场电子计时收费装置(系统)(以下简称计时收费装置)的首次检定、后续检定和使用中检查。

Electronic Parking Meters

ICS
CCS
T36
发布
2013-04-27
实施
2013-10-27

本标准规定了汽车用电源总开关的定义、要求、试验方法、检验规则、标志、包装、运输和储存。本标准适用于额定电压12V、24V的汽车用机械式、电磁式电源总开关(以下简称开关)。

Automobile use battery main switch technical requirement

ICS
43.040.10
CCS
T36
发布
2013-04-25
实施
2013-09-01

The ""System Emissions Chart"" contained herein is intended to serve as a means of estimating the annual refrigerant emission rate (grams per year) from new production A/C systems equipped with specified component technologies. It provides emission values for various component technologies that are currently available, and can be expanded as new technologies are commercialized. This document provides the information to develop an Excel file template ""System Emissions Chart"" for system emission analysis. The chart includes automotive compressor technologies for conventional mobile air conditioning systems as well as those using semi-hermetic compressors. T

Mobile Air Conditioning System Refrigerant Emission Charts for R-134a and R-1234yf

ICS
43.040.60
CCS
T36
发布
2013-04-03
实施
2013-04-05

Road vehicles. Degrees of protection (IP code). Protection of electrical equipment against foreign objects, water and access

ICS
43.040.10
CCS
T36
发布
2013-03-31
实施
2013-03-31

This SAE Recommended Practice provides test procedures, requirements, and equipment recommendations for the methods of the measurement that characterizes potential design failures by utilizing a step stress approach to subject a device under test to thermal, vibration, and electrical stresses of types and levels beyond what it may see in actual use, but which will rapidly induce failure modes, allowing them to be detected and corrected.

Highly Accelerated Failure Test (HAFT) for Automotive Lamps with LED Assembly

ICS
43.040.20
CCS
T36
发布
2013-03-26
实施
2018-05-29



Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号