共找到 740 条与 模具 相关的标准,共 50 页
This standard specifies the characteristics, qualification and acceptance requirements for drivers for installing and removing screws and bolts having six lobe recess internal drive.
Aerospace series - Six lobe recess - Drivers - Technical specification
This standard specifies the characteristics of drivers, handle, six lobe recess, for aerospace applications.
Aerospace series - Six lobe recess - Drivers, handle
This standard specifies the characteristics of drivers, short, six lobe recess, for aerospace applications.
Aerospace series - Six lobe recess - Drivers, short
This standard specifies the characteristics of drivers, relieved, six lobe recess, for aerospace applications.
Aerospace series - Six lobe recess - Drivers, relieved
Test method for properties of investment casting slurry-Part 8:The laser speedy mensuration method for the determination of refractory powder granularity
Test method for properties of investment casting shell-Part 3:Determination of deformation under load at elevated temperature
Test method for properties of investment casting shell-Part 4:Determination of permeability to gas
Test method for properties of investment casting slurry-Part 3:The volumetry for the determination of density
Test method for properties of investment casting slurry-Part 5:The pH-meter method for the determination of acidity
Test method for properties of investment casting slurry-Part 4:The pH test paper method for the determination of acidity
Test method for properties of investment casting pattern materials-Part 2:Determination of thermal deformation and thermal stability
Test method for properties of investment casting slurry-Part 7:The torque balance sedimentation analytical method for the determination of refractory powder granularity
本标准适用于测定型壳试样在室温和1500℃温度范围内加载情况下的抗弯强度。
Test method for properties of investment casting shell-Part 1:Determination of bending strength
本标准适用于型壳试样在自重下,从700~1600℃温度范围内的热变形值的测定。
Test method for properties of investment casting shell-Part 2:Determination of deformation under weight at elevated temperature
Test method for properties of investment casting pattern materials-Part 5:Determination of ash content
Test method for properties of investment casting pattern materials-Part 6:Determination of wetting angle between pattern an binder
Test method for properties of investment casting pattern materials-Part 3:Determination of bending strength
Test method for properties of investment casting pattern materials-Part 6:Determination of viscosity
本标准适用于硅酸乙酯涂料及比重≤2.00的硅深胶涂料的比重测定。
Test method for properties of investment casting slurry-Part 2:The densimeter method for the determination of density
本部分规定了熔模铸造模料线收缩率测定方法的原理、仪器设备、试样、试验步骤、试验结果及处 理和试验报告。 本部分适用于熔模铸造模料线收缩率的测定。
Test method for properties of investment casting pattern materials-Part 1:Determination of linear shrinkage
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号