ANSI/CSA AMERICA FC 1-2004
固定式燃料电池发电系统

Stationary Fuel Cell Power Systems

ANSI/CSA AMERICA FC 1-2004 发布历史

ANSI/CSA AMERICA FC 1-2004由SCC 发布于 2004-01-01。

ANSI/CSA AMERICA FC 1-2004在国际标准分类中归属于: 27.070 燃料电池。

ANSI/CSA AMERICA FC 1-2004 固定式燃料电池发电系统的最新版本是哪一版？

最新版本是 ANSI/CSA AMERICA FC 1-2004 。

ANSI/CSA AMERICA FC 1-2004的历代版本如下：

• 2004年 ANSI/CSA AMERICA FC 1-2004 固定式燃料电池发电系统

ANSI/CSA AMERICA FC 1-2004 由 ANSI Z21.83-1998 燃料电池发电厂 变更而来。

ANSI/CSA AMERICA FC 1-2004 于 2012-03-01 变更为 ANSI FC 1-2012 固定式燃料电池发电系统。

1.1 Scope and References 1.1.1 This standard applies to stationary fuel cell power systems that are packaged, self-contained or factory matched packages of integrated systems (see 1.2.1), which through electrochemical reactions and other processes, generate alternating-current or direct-current electricity. Such systems are herein referred to as fuel cell power system(s). 1.1.2 This standard applies to stationary fuel cell power systems when intended for operation with fuels listed in 1.1.3: a. At an output voltage not exceeding nominal 600 VAC or 600 VDC; and b. At a power output not exceeding 10 MW. Exception: Output voltage may exceed nominal 600 VAC up to nominal 15,000 VAC in accordance with A.1.31 (see Exhibit A, Electrical Equipment and Wiring). 1.1.3 Stationary fuel cell power systems examined for compliance with this standard shall be for use with: a. Natural gas, methane gas mixtures; and/or b. Liquefied petroleum gases; and/or c. Methanol, ethanol (or other alcohol fuel), kerosene, diesel, gasoline (or other liquid hydrocarbons); and/or d. Hydrogen gas; and/or e. Zinc particulate conveyed in a non-flammable liquid medium. 1.1.4 Exhibit A contains coverage for electrical equipment and wiring. 1.1.5 Publications of nationally-recognized standards and codes referenced herein are listed in Exhibit B, List of Reference Standards. When applicable, other nationally-recognized publications may be utilized to supplement those referenced herein. In the absence of applicable publications, the manufacturer may submit other evidence of conformance to the testing agency. However, acceptance of such evidence shall be left at the discretion of the testing agency. 1.1.6 If a value for measurement as given in this standard is followed by an equivalent value in other units, the first stated value is to be regarded as the specification. Conversion factors for quantities stated herein are listed in Appendix F, Table of Conversion Factors. SI Units stated herein are in accordance with the Standard for Use of the International System of Units: The Modern Metric System, IEEE/ASTM SI 10. 1.1.7 All references to psi throughout this standard are to be considered gage pressure unless otherwise specified.

标准号

ANSI/CSA AMERICA FC 1-2004

发布

2004年

发布单位

SCC

当前最新

ANSI/CSA AMERICA FC 1-2004

 

 

代替标准

ANSI FC 1-2012

被代替标准

ANSI Z21.83-1998

ANSI/CSA AMERICA FC 1-2004相似标准

推荐