ANSI/CSA AMERICA FC 1-2004
固定式燃料电池发电系统

Stationary Fuel Cell Power Systems

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 ANSI/CSA AMERICA FC 1-2004 前三页，或者稍后再访问。

您也可以尝试购买此标准，
点击右侧 “立即购买” 按钮开始采购（由第三方提供）。

标准号

ANSI/CSA AMERICA FC 1-2004

发布

2004年

发布单位

SCC

当前最新

ANSI/CSA AMERICA FC 1-2004

 

 

代替标准

ANSI FC 1-2012

被代替标准

ANSI Z21.83-1998

适用范围

1.1 Scope and References 1.1.1 This standard applies to stationary fuel cell power systems that are packaged, self-contained or factory matched packages of integrated systems (see 1.2.1), which through electrochemical reactions and other processes, generate alternating-current or direct-current electricity. Such systems are herein referred to as fuel cell power system(s). 1.1.2 This standard applies to stationary fuel cell power systems when intended for operation with fuels listed in 1.1.3: a. At an output voltage not exceeding nominal 600 VAC or 600 VDC; and b. At a power output not exceeding 10 MW. Exception: Output voltage may exceed nominal 600 VAC up to nominal 15,000 VAC in accordance with A.1.31 (see Exhibit A, Electrical Equipment and Wiring). 1.1.3 Stationary fuel cell power systems examined for compliance with this standard shall be for use with: a. Natural gas, methane gas mixtures; and/or b. Liquefied petroleum gases; and/or c. Methanol, ethanol (or other alcohol fuel), kerosene, diesel, gasoline (or other liquid hydrocarbons); and/or d. Hydrogen gas; and/or e. Zinc particulate conveyed in a non-flammable liquid medium. 1.1.4 Exhibit A contains coverage for electrical equipment and wiring. 1.1.5 Publications of nationally-recognized standards and codes referenced herein are listed in Exhibit B, List of Reference Standards. When applicable, other nationally-recognized publications may be utilized to supplement those referenced herein. In the absence of applicable publications, the manufacturer may submit other evidence of conformance to the testing agency. However, acceptance of such evidence shall be left at the discretion of the testing agency. 1.1.6 If a value for measurement as given in this standard is followed by an equivalent value in other units, the first stated value is to be regarded as the specification. Conversion factors for quantities stated herein are listed in Appendix F, Table of Conversion Factors. SI Units stated herein are in accordance with the Standard for Use of the International System of Units: The Modern Metric System, IEEE/ASTM SI 10. 1.1.7 All references to psi throughout this standard are to be considered gage pressure unless otherwise specified.

ANSI/CSA AMERICA FC 1-2004相似标准

推荐