共找到 498 条与 电磁兼容性(EMC) 相关的标准,共 34 页
本标准规定了城市无线电噪声场强的地面测量方法及数据处理方法。 本标准适用于0.15~1000MHz无线电业务的保护。
Methods of measurment for urban radio noise
本标准规定了陆地移动通信设备的传导发射、传导敏感度、辐射发射、辐射敏感度等要求、极限值和测量方法。 本标准适用于陆地移动通信业务使用的,工作频率25~1 000MHz,发射功率不超过150W的设备。1.6~30MHz单边带电台也可参照执行。
EMC specification and test methods for land mobile communication equipment
本标准规定了由内燃机、电动机或二者推动的车辆、机动车群、机动船或装有火花点火内燃机装置的干扰引起移动通信性能降级的评定方法。 本标准适用于工作频率为25~1000MHz的移动的接收机设备和系统。 本标准仅限于评定话音通信质量的降级。 车辆包括各种汽车、摩托车、拖拉机及摩托雪撬等;机动船也认为是车辆的一种。 装置包括链式锯、灌溉泵、空压机、割草机、固定式和移动式混凝土搅拌机等。 本标准不适用于飞机、铁路上牵引系统引起的干扰。
Methods of judging degradation for interference to mobile radiocommunication in the presence of impulsive noise
本标准规定了海岸电台高频无线电话通信中的电波传播损耗和频道干扰的计算方法,并规定了高频无线电话通信中海岸电台收信台的最小可用信号场强。
Interference calculation methods of coast radiotelephone station operating in high frequency bands
本标准规定了1400MHz以下地面无线电业务的信号/干扰射频保护比和最小可用场强。 本标准适用于无线电业务之间的干扰协调、无线电频率管理部门进行频率管理及各种地面无线电业务网络的规划和设计。
Protection ratios and minimum usable field strengths required in the radio services
本标准给出了模拟微波与数字微波接力通信系统的干扰容限、干扰类型以及干扰计算方法。其中包括路径传输损耗、地形影响、雷达干扰以及不同调制方式的系统干扰计算等。 本标准适用于1~40GHz频段,微波接力通信系统之间以及雷达系统对模拟微波接力通信系统的干扰计算。 本标准是微波通信系统之间干扰协调的主要依据和验算手段,也是各种容量微波通信系统的总体设计、电路建设以及维护的依据。
Interference calculation methods for radio-relay systems
本标准规定了高压电器设备无线电干扰测试方法。 本标准适用于交流高压开关设备、电压互感器、电流互感器、耦合电容器、避雷器、绝缘子及金具等高压电器设备的无线电干扰测试。
Test methods for measuring radio interference from high voltage equipment
Electromagnetic compatibility of electrical and electronic installations in ships
The technical requirements of operational frequency distribution and anti-interference of sound for fish finders
本标准规定了同轴电缆载波通信系统受无线电广播和通信干扰的允许值。 本标准适用于地下同轴电缆载波通信系统和载波通信设备,以及同轴电缆线路。
Immunity specification of coaxial cable carrier system to the interference from the radio broadcasting and telecommunication
本标准规定了架空明线载波通信系统受无线电广播和通信干扰的允许值。 本标准适用于架空明线载波通信系统和载波通信设备,以及明线线路。
Immunity specification of open wire carrier system to the interference from the radio broadcasting and telecommunication
本标准规定了对称电缆载波通信系统受无线电广播和通信干扰的允许值。 本标准适用于地下对称电缆载波通信系统和载波通信设备,以及对称电缆线路。
Immunity specification of symmetrical cable carrier system to the interference from the radio broadcasting and telecommunication
本标准为电气设备抗干扰特性的基本测量方法。 本标准适用于: a.测量电气设备的电磁敏感度。 b.考核电气设备的抗干扰性能是否符合产品技术条件规定的电磁敏感度界限值。 在符合本标准要求的前提下,各类电气设备可制订相应的抗干扰特性测量方法和规定需要进行的测试项目。
General methods of measurement of immunity to interference for electrical equipment
本标准适用于对无线电接收造成干扰的下列工业干扰源: a.电机、低压电器和电子设备; b.工业、科学、医疗设备; c.机动车辆和其他点火装置; d.收音机和电视接收机; e.家用电器、电动工具及类似器具。 本标准适用的频率范围为10kHz至1000MHz。 本标准主要是参照国际无线电干扰特别委员会(C.I.S.P.R.)第16号出版物《无线电干扰测量设备及测量方法规范》制订的。
General methods of measurement for industrial radio interference
本文件适用于12V系统和24V系统的车辆后装电气/电子设备。
Electromagnetic Compatibility Requirements and Measurement Methods for Vehicle Rear-installed Electrical/Electronic Equipment
Electromagnetic compatibility — Electromagnetic safety management guideline
Electromagnetic compatibility(EMC) — Part 5-4: Installation and mitigation guidelines — Immunity to HEMP — Specifications for protective devices against HEMP radiated disturbance —Basic EMC publicatio
Electromagnetic compatibility(EMC) — Part 5-4: Installation and mitigation guidelines — Immunity to HEMP — Specifications for protective devices against HEMP radiated disturbance —Basic EMC publicatio
Electrical and electronic installations in ships – Electromagnetic compatibility (EMC) – Ships with a non-metallic hull
本文件规定了无线局域网天线的测量条件、测量方法和步骤。 本文件适用于通信系统中无线局域网基站及终端设备天线的测量, 其他无线通信天线的测量方法参照执行。
WLAN Antenna Measurement Method
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号