T51 市政专用汽车 标准查询与下载

GA 879-2010 警用淋浴汽车

本标准规定了警用淋浴汽车的术语和定义、分类与代号、技术要求、试验方法、检验规则、标志、运输和贮存。 本标准适用于采用国家允许生产和销售的汽车或二类汽车底盘改装的警用淋浴汽车。

Police shower vehicle

GA 880-2010 警用警犬输送车

本标准规定了警用警犬输送车的术语和定义、分类与代号、技术要求、试验方法、检验规则、标志、运输和贮存。 本标准适用于采用国家允许生产和销售的汽车整车或二类底盘改装的警用警犬输送车。

Police vehicle for transport of trained dog

GA 881-2010 警用轻型移动式路障车

本标准规定了警用轻型移动式路障车的术语和定义、代号、技术要求、试验方法、检验规则、标志、运输和贮存。 本标准适用于采用国家允许生产和销售的汽车整车或二类底盘改装的警用轻型移动式路障车。

Police traveling road-block light vehicle

BS EN 15597-1:2009 冬季维护设备.涂胶机(铺砂机).涂胶机的一般要求和定义

Demands on design and construction of bulk spreaders, trailer spreaders and towed spreaders with speed related spreading for winter service are determined by this document. At the same time, information is given on the minimum content required for operating manuals. The standard is valid for machines which are used to spread the following media: a) spreading agents with or without pre-wetted agent; b) abrasive spreading agents; c) brine. The following points are not covered by this standard: ? requirements for registration and approval; ? requirements made by automobile manufacturers; ? requirements on safety – these are dealt with in EN 13021.

Winter maintenance equipment - Spreading machines (gritting machines) - General requirements and definitions for spreading machines

GA 876-2010 警用车辆产品分类及型号编制规则

本标准规定了警用车辆的术语和定义、车辆产品分类及型号的构成。 本标准适用于警用车辆即警用特种车辆、警用勤务车辆和警用保障车辆的分类和型号编制。

Classification and type coding rules for police vehicles

GA 874-2010 警用越野突击车

本标准规定了警用越野突击车的术语和定义、代号、技术要求、试验方法、检验规则、标志、运输及贮存。 本标准适用于警用越野突击车。

Police off-road assault vehicles

DIN EN 1501-3:2010 垃圾收集车及其相关提升装置.一般要求及安全性要求.第3部分:前端装载式垃圾收集车.德文版本EN 1501-3-2008

Refuse collection vehicles and their associated lifting devices - General requirements and safety requirements - Part 3: Front loaded refuse collection vehicles; German version EN 1501-3:2008

DIN EN 1501-2:2010 垃圾收集车及相关提升装置.一般要求和安全性要求.第2部分:侧面装载的垃圾收集车.德文版本EN 1501-2-2005+A1-2009

This document contains the Amendment A1 due to the New Approach Directive 2006/42/EC on machinery.

Refuse collection vehicles and their associated lifting devices - General requirements and safety requirements - Part 2: Side loaded refuse collection vehicles; German version EN 1501-2:2005+A1:2009

DIN EN 1501-1:2010 垃圾收集车及其相关提升装置.一般要求和安全性要求.第1部分:尾部装载垃圾收集车.德文版本EN 1501-1-1998+A2-2009

The document specifies the safety and design requirements for the bodywork of rear loaded refuse collection vehicles (rear loaded RCVs) for the collection, transportation and discharge of solid waste materials and recyclable materials operated by hydraulic power.

Refuse collection vehicles and their associated lifting devices - General requirements and safety requirements - Part 1: Rear-end loaded refuse collection vehicles; German version EN 1501-1:1998+A2:2009

NF R17-112-2:2010 垃圾集运车辆及其辅助升降装置.一般要求和安全要求.第2部分:侧面装载的垃圾收集车

Refuse collection vehicles and associated lifting devices - General requirements and safety requirements - Part 2 : side loaded refuse collection vehicles.

NF R17-112-2/IN1:2010 垃圾集运车辆及其辅助升降装置.一般要求和安全性要求.第2部分:侧面装载的垃圾收集车

Refuse collection vehicles and associated lifting devices - General requirements and safety requirements - Part 2 : side loaded refuse collection vehicles.

NF R17-112-1/IN2:2010 垃圾收集车及其相关升降装置.一般要求和安全要求.第1部分:尾部装载式垃圾收集车

Refuse collection vehicles and their associated lifting devices - General requirements and safety requirements - Part 1 : rear-end loaded refuse collection vehicles.

QC/T 807-2009 除雪车

本标准规定了除雪车的术语、要求、试验方法、检验规则、标志和使用说明书、随车文件和运输、储存。 本标准适用于采用已定型汽车整车或二类底盘基础上改装的城市道路及高速公路、机场路面除雪为主的除雪车及除雪半挂车。

Snow removal vehicle

QC/T 811-2009 沥青道路微波养护车

本标准规定了沥青道路微波养护车的术语和定义、要求、试验方法、检验规则、标志、包装、运输及贮存。 本标准适用于采用已定型汽车或二类底盘改装的沥青道路微波养护车。 沥青道路微波养护车挂车参照本标准。

The microwave maintenance vehicle for bituminous pavement

DIN EN 15583-1:2009 冬季维修设备.除雪机.第1部分:产品说明和要求.英文版本DIN EN 15583-1-2009-09

This document is valid for snow ploughs designed to be fitted to winter maintenance vehicles, on their front- mounting plates according to EN 15432 and also for side-mounted snow ploughs. Demands on design and construction of front-mounted or side-mounted snow ploughs for winter service are determined by this document. This document is meant to assess the demands made on snow ploughs operated in traffic. The document is valid for: -- single-side snow ploughs; -- variable V-ploughs. The following points are not standardized by this document: v-shaped snow ploughs; -- requirements for registration and approval; -- requirements made by carrier vehicle manufacturers; -- requirements on safety-these are dealt with in EN 13021.

Winter maintenance equipment - Snow ploughs - Part 1: Product description and requirements; English version of DIN EN 15583-1:2009-09

NF P98-916-1*NF EN 15429-1:2009 清扫机.第1部分:分类和术语

Sweepers - Part 1 : classification and terminology.

BS EN 15583-1:2009 冬季用维护设备.扫雪机.第1部分:产品说明和要求

This document is valid for snow ploughs designed to be fitted to winter maintenance vehicles, on their frontmounting plates according to EN 15432 and also for side-mounted snow ploughs. Demands on design and construction of front-mounted or side-mounted snow ploughs for winter service are determined by this document. This document is meant to assess the demands made on snow ploughs operated in traffic. The document is valid for: -single-side snow ploughs; -variable V-ploughs. The following points are not standardized by this document: -v-shaped snow ploughs; -requirements for registration and approval; -requirements made by carrier vehicle manufacturers; -requirements on safety – these are dealt with in EN 13021.

Winter maintenance equipment - Snow ploughs - Part 1:Product description and requirements

DIN EN 13019:2009 路面清洁机 安全要求

This European Standard applies to road surface cleaning machines, which are defined in clause 3. The equipment would normally be mounted on a carrier vehicle (e.g. truck, tractor, construction machinery and mobile industrial handling equipment). It is also possible to mount a road surface cleaning machine on its own chassis construction and propulsion system. In all cases the machine and chassis form an integral unit. Directives and standards for the vehicular truck chassis aspect, termed 'carrier vehicle' in this standard, would be those relative to that equipment, even where specific modifications have been made to realize the road surface cleaning application. The use in public road traffic is governed by the national regulations. This European Standard deals with all significant hazards identified through a risk assessment pertinent to road surface cleaning machines when they are used as intended and under the conditions foreseen by the manufacturer. This European Standard does not deal with significant hazards associated with deleted text EMC. This European Standard only specifies the appropriate technical measures to eliminate or reduce risks arising from the significant hazards associated with machine operation, setting and adjustments, load discharge and routine maintenance. This European Standard does not include requirements for the carrier vehicles (e.g. truck) or special constructions. These are covered in directives related to the construction of vehicles. Demountable bodywork systems (e.g. demountable containers) are specified in other standards. This European Standard does not apply to road surface cleaning machines such as front mounted tractor brooms according to EN 13524:2003. This European Standard does not apply to machines or components that are specifically designed for cleaning tram-lines and rail tracks. This European Standard does not deal with the risks associated with the operation of machines in potentially explosive atmospheres. This European Standard applies to machines which are manufactured after the date of approval of the standard by CEN.

Machines for road surface cleaning - Safety requirements (includes Amendment A1:2008) ; English version of DIN EN 13019:2009-04

DIN EN 13021:2009 冬季服务设施 安全要求

This European Standard applies to winter service machines which are defined in clause 3. This European Standard deals with all significant hazards (see clause 4) identified through a risk assessment pertinent to winter service machines when they are used as intended and under the conditions foreseen by the manufacturer. This European Standard does not deal with significant hazards associated with deleted text EMC. This European Standard specifies the appropriate technical measures to eliminate or reduce risks arising from the significant hazards associated only with machine operation, setting and adjustments, load discharge and routine maintenance. Winter service machines are normally mounted on carrier vehicles (e.g. trucks, tractors, construction machinery and mobile industrial handling equipment). This European Standard does not cover requirements for the carrier vehicles even where specific modifications have been made to realise the winter service application. These requirements will be handled in directives and standards for the construction of carrier vehicles. The use of winter service machines in public road traffic is governed by national regulations. This standard does not cover any requirements for demountable bodywork systems (e.g. demountable containers). These requirements are specified in other standards. This European Standard does not deal with: -- machines or components which are solely designed for clearing rails such as rail sweepers or blowers; -- walker-operated and hand-held winter service machines; -- highway maintenance machines covered by EN 13524, such as front-mounted sweepers; -- machines for the maintenance of sports grounds; -- machines for agriculture, horticulture and forestry; -- machines intended for use in potentially explosive atmospheres. This European Standard applies to winter service machines which are manufactured after the date of approval of the standard by CEN.

Winter service machines - Safety requirements (includes Amendment A1:2008); English version of DIN EN 13021:2009-04

BS EN 1501-3:2008 垃圾收集车及其相关提升装置.一般要求和安全要求.前端载荷垃圾收集车辆

This standard applies to front loaded refuse collection vehicles, as defined in 3.2, and specifies their technical requirements. This standard deals with all significant hazards, hazardous situations and events relevant to the front loaded RCV, when it is used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer (see Clause 4). This standard part 3 describes and gives the requirements of the front loaded RCV and the associated lifting device(s) and refers to part 4 of this series of standards for the noise test code.

Refuse collection vehicles and their associated lifting devices — General requirements and safety requirements Part 3: Front loaded refuse collection vehicles