T51 市政专用汽车 标准查询与下载

BS EN 1501-3:2009 垃圾收集车及其相关提升装置.一般要求和安全要求.前端载荷垃圾收集车辆

Refuse collection vehicles and their associated lifting devices - General requirements and safety requirements - Front loaded refuse collection vehicles

NF E58-170/IN1:2009 道路表面清洁机.安全要求

Machines for road surface cleaning - Safety requirements.

NF E58-170:2009 道路表面清洁用机械.安全性要求

Machines for road surface cleaning - Safety requirements.

NF E58-172/IN1:2009 冬季服务机器.安全要求

Winter service machines - Safety requirements.

NF E58-172:2009 冬季使用的机械.安全性要求

Winter service machines - Safety requirements.

DIN EN 1501-3:2008 垃圾收集车及其相关提升装置.一般要求和安全要求.第3部分:前部装载式垃圾收集车.德文版本EN 1501-3-2008

This standard applies to front loaded refuse collection vehicles, as defined in 3.2, and specifies their technical requirements. This standard deals with all significant hazards, hazardous situations and events relevant to the front loaded RCV, when it is used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer (see Clause 4). This standard part 3 describes and gives the requirements of the front loaded RCV and the associated lifting device(s) and refers to part 4 of this series of standards for the noise test code. Examples for standard types of front loaded refuse collection vehicles are given in Annex C. This European Standard is not applicable to: -- operation in severe conditions (e.g. extreme environmental conditions such as: temperatures below -25 ℃ and above 40 ℃, corrosive environment, tropical environment, lightning, wind velocity in excess of 75 kin/h); -- operation subject to special rules (e.g. potentially explosive atmospheres, contaminating environments); -- transportation of passengers, lifting of persons; -- loading bycrane; -- loading by satellite vehicle; -- containers other than defined in EN 840-1 to -4, EN 12574-1 to -3 and type B of EN 13071; -- handling of loads the nature of which could lead to dangerous situations such as hot wastes, acids and bases, radioactive materials, especially fragile loads, explosives. This document is not applicable to machinery which is manufactured before the date of its publication by CEN.

Refuse collection vehicles and their associated lifting devices - General requirements and safety requirements - Part 3: Front loaded refuse collection vehicles; German version EN 1501-3:2008

SAE J1790-2008 自力推进式清扫器和擦洗器方向控制要求.单路液压继动设备

The SAE Standard applies to self-propelled, driver-operated sweepers and scrubbers as defined in SAE J2130.

Self-Propelled Sweepers and Scrubbers Steering Requirements Single-Circuit Hydraulic Servo-Assisted Systems

BS EN 15429-1:2007 扫路机.第1部分:分类和术语

This document applies to surface cleaning machines for outdoor applications on public areas, roads, airports and industrial plants. Cleaning machines for winter maintenance or indoor applications are not under the scope of this European Standard. Surface cleaning machines in terms of this Standard are self propelled, truck mounted, attached sweeping equipment or pedestrian controlled. This document deals with the classification of sweeping equipment and its performance specifications when they are used as intended and under the conditions foreseen by the manufacturer. This document does not include the carrier vehicles (e.g. truck). These will be handled in national or EC Directives for vehicles. This document does not apply to road surface cleaning machines such as front mounted on tractors according to EN 13524, or other vehicles. This document does not apply to machines or components that are specifically designed for cleaning tram lines and rail tracks. This document applies to machines that are manufactured after the date of approval of this standard by CEN. Industrial sweepers within the scope of EN 60335-2-72 are excluded.

Sweepers - Part 1: Classification and Terminology

DIN EN 15429-1:2008 扫路机.第1部分:分类和术语

This document applies to surface cleaning machines for outdoor applications on public areas, roads, airports and industrial plants. Cleaning machines for winter maintenance or indoor applications are not under the scope of this European Standard. Surface cleaning machines in terms of this Standard are self propelled, truck mounted, attached sweeping equipment or pedestrian controlled. This document deals with the classification of sweeping equipment and its performance specifications when they are used as intended and under the conditions foreseen by the manufacturer. This document does not include the carrier vehicles (e.g. truck). These will be handled in national or EC Directives for vehicles. This document does not apply to road surface cleaning machines such as front mounted on tractors according to EN 13524, or other vehicles. This document does not apply to machines or components that are specifically designed for cleaning tram lines and rail tracks. This document applies to machines that are manufactured after the date of approval of this standard by CEN Industrial sweepers within the scope of EN 60335-2-72 are excluded.

Sweepers - Part 1: Classification and Terminology; English version of DIN EN 15429-1:2008-01

DIN EN 1501-4:2008 垃圾收集车及其相关提升装置.一般要求和安全性要求.第4部分:垃圾收集车的噪声试验规范

This European Standard specifies the method for measuring the noise emission, which is a significant hazard of refuse collection vehicles (RCVs). Its goal is to obtain, on one hand, the emission sound pressure level at the operator's position(s) and, on the other hand, the sound power level of the RCV during waste collection. It specifies a standardized procedure for measurement and later comparison of RCVs noise emission, consisting of four operating conditions: chassis operation, compaction operation, lifting, tilting and lowering operation of a container and dumping of specified waste into the RCV. Together with information concerning other parameters, the test results obtained in accordance with this standard are also applicable to the evaluation of the hazards generated by noise from RCVs. This standard addresses the uncertainties due to measurement procedures. This standard deals with the noise measurement conditions for the types of RCVs defined and described in the standards of the EN 1501 series.

Refuse collection vehicles and their associated lifting devices - General requirements and safety requirements - Part 4: Noise test code for refuse collection vehicles; English version of DIN EN 1501-4:2008-01

UL 1090-2007 电动除雪机

These requirements cover battery-powered snow movers, and cord-connected electrically operated snow movers rated 250 Vs or less to be employed in accordance with the National Electrical Code, NFPA 70. These requirements do not cover riding-type snow movers or snow movers intended for commercial or industrial use or for use in hazardous locations as defined in the National Electrical Code, NFPA 70. In addition to the requirements in this standard, a snow mover shall comply with, Sections 4.1, 4.2.1 - 4.2.3, 4.2.5, 5, 6, 9.1 - 9.5, 10.1, and 11 of the Safety Specifications for Snow Throwers, ANSI B71.3.Markings shall be considered durable and permanent if they comply with Permanency of Marking, Section 42 of this standard.

Electric snow movers

DIN 30704:2007 道路表面清洁用车辆.扫路机、洗涤车和组合车辆

Machines for road surface cleaning - Sweepers, washing vehicles and combinations thereof

SAE J1792-1-2007 自动推进的扫路机空气流动性能.第1部分:吸入空气量性能

This SAE Standard establishes a test method and a definition for disclosing the suction air volume performance of self-propelled sweepers that solely use a pneumatic conveyance means for the collection and transfer of "sweepings" into a collection hopper. The purpose of the document describes a test practice for measuring the suction air movement occurring in vacuum and regenerative air street sweepers described in SAE J 2130. The document also proposes a format for the presentation of the results. The document can be used to disclose or compare particular operating performance criteria under similar conditions.

Self-Propelled Sweepers Air Flow Performance Part 1: Suction Air Volume Performance

DB11/T 347-2006 餐厨垃圾车技术要求

本标准适用于餐厨垃圾车系列产品

Technical criteria on trucks for kitchen-remainings removal

SAE J2474-2006 电池驱动的自推式扫路机和硬毛刷.修整

This SAE Standard applies to all electric battery-powered machines that fall within the scope of SAE J 2130. To define a uniform method of determining the time a battery-powered machine will continue operating normally with a given set of batteries.

Self Propelled Sweepers and Scrubbers Battery Run-Tim

QC/T 54-2006 洒水车

本标准规定了洒水车的术语和定义、要求、试验方法、检验规则、标志、适用说明书、及随车文件、运输和储存。 本标准适用于利用定型汽车二类底盘改装的洒水车和洒水半挂车。

Street sprinklers

QC/T 51-2006 扫路车

本标准规定了扫路车的术语和定义、要求、试验方法、检验规则、标志、适用说明书及随车文件、运输和储存。 本标准适用于各类扫路车。

Sweeper truck

QC/T 53-2006 吸粪车

本标准规定了吸粪车的术语、要求、试验方法、检验规则、标志、适用说明书及随车文件、运输和储存。 本标准适用于各类吸粪车。

Suction-type excrement tanker

QC/T 750-2006 清洗车通用技术条件

本标准规定了清洗车的术语和定义，要求，试验方法，检验规则，标志，使用说明书及包装、运输和储存。 本标准适用于采用定型汽车二类底盘改装，用于清洗路面、管道及墙面的清洗车。

General specifications for cleaning tanker

QC/T 749-2006 绿化喷洒车

本标准规定了绿化喷洒车（以下简称喷洒车）的术语，要求，试验方法，检验规则，标志，使用说明书及随车文件、运输和储存。 本标准适用于采用定型汽车二类底盘改装的喷洒车。

Tree sprinkling tanker