97.190 儿童用器具 标准查询与下载

T/PWSBZ 0001-2022 儿童自行车安全要求

本标准适用于四岁至十岁的儿童骑行的儿童自行车（鞍座高度在435mm和635mm之间）。这类自行车不能用于公路骑行，因此不应推定它须要具有适用于作公路骑行装备（鞍座高度小于435mm的玩具自行车应符合GB6675《国家玩具安全技术规范》的要求）。 凡符合本标准要求的儿童自行车就不是玩具自行车，因此也不属于玩具安全的范畴。

Children's Bicycle Safety Requirements

ASTM F2670-22 婴儿浴缸的消费者安全标准规范

1.1 This consumer safety specification establishes performance requirements, test methods, and labeling requirements to promote the safe use of infant bath tubs. It also covers slings, pads, inserts, and similar accessories when such accessories are used with the infant bath tub. 1.2 This consumer safety specification is intended to reduce the risk of death and minimize injury to infants resulting from use and reasonably foreseeable abuse of infant bath tubs and infant bath tub accessories. 1.3 No infant bath tub or infant bath tub accessory produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5 The following precautionary caveat pertains only to the test methods portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Consumer Safety Specification for Infant Bath Tubs

22/30447473 DC BS EN 12221 儿童护理用品 家用换尿布台和换尿布垫 安全要求及测试方法

BS EN 12221. Child care articles. Changing units and changing pads for domestic use. Safety requirements and test methods

ASTM F2194-22 摇篮和摇篮的消费者安全标准规范

Standard Consumer Safety Specification for Bassinets and Cradles

ASTM F2194-22e1 摇篮和摇篮的消费者安全标准规范

1.1 This consumer safety specification covers performance requirements, test methods, and marking requirements to promote safe use of bassinets and cradles. 1.2 This consumer safety performance specification is intended to minimize the risks of incidents to an infant resulting from normal use and reasonably foreseeable misuse of a bassinet or cradle. 1.3 This consumer safety performance specification covers products primarily intended to provide sleeping accommodations for an infant up to approximately 5 months in age or when the child begins to push up on hands and knees, whichever comes first. 1.3.1 Examples of Products under the Scope: 1.3.1.1 Bassinets, cradles, compact bassinets, and compact cradles. 1.3.1.2 Cradle swings with an incline less than or equal to 10° from horizontal while in the rest (non-rocking) position. 1.3.1.3 Multi-use products when they are in the bassinet/ cradle or compact bassinet/cradle use mode as defined in 3.1.1 or 3.1.3. 1.3.1.4 Bassinet/cradle accessories to products when removed from the product and used in the bassinet/cradle mode or as a compact bassinet/cradle product. See 3.1.2 for an example. 1.3.1.5 Bassinet/cradle features for carriage/stroller when removed from the carriage/stroller and used in the bassinet/ cradle mode or compact bassinet/cradle product mode. 1.3.2 Examples of Products Excluded from the Scope: 1.3.2.1 Sleep products that have only inclined sleeping surfaces intended to be greater than 10° from horizontal while in the rest (non-rocking) position. 1.3.2.2 In-bed portable sleepers. 1.3.2.3 Enclosed travel tents. 1.4 No bassinet or cradle produced after the approval date of this consumer safety performance specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein. 1.5 This consumer safety performance specification is not intended to address incidents and injuries resulting from alteration or unreasonable abuse or misuse of the product by a child or child care giver. 1.6 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.7 The following precautionary caveat pertains only to the test method portion Section 7 of this consumer safety performance specification This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1 This specification is under the jurisdiction of ASTM Committee F15 on Consumer Products and is the direct responsibility of Subcommittee F15.18 on Cribs, Toddler Beds, Play Yards, Bassinets, Cradles and Baby Changing Products. Current edition approved Jan. 1, 2022. Published June 2022. Originally approved in 2002. Last previous edition approved in 2016 as F2194 – 16ɛ1 . DOI: 10.1520/ F2194-22E01. Copyright © ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. 1 1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Consumer Safety Specification for Bassinets and Cradles

ASTM F2907-21 吊索托架的标准消费者安全规范

Standard Consumer Safety Specification for Sling Carriers

T/JXAS 013-2021 儿童脚踏卡丁车

本文件规定了儿童脚踏卡丁车（以下简称“卡丁车”）的术语和定义、技术要求、试验方法、检验规则、标志、包装、运输和贮存。

Pedaled Karting for Children

ASTM F2388-21 家用婴儿更换产品的消费者安全标准规范

1.1 This consumer safety specification covers performance requirements, test methods, and labeling requirements to promote the safe use of baby changing products including changing tables, changing table accessories, contoured changing pads, and add-on changing units. 1.2 This specification covers products sold for domestic use for children up to a weight of 30 lb (13.6 kg). 1.3 Changing products shall meet all applicable performance and labeling requirements. 1.4 No changing product produced after the approval date of this specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all applicable requirements contained herein, before, and after all testing. 1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.6 The following precautionary caveat pertains only to the test method portion in Section 7 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory requirements prior to use. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Consumer Safety Specification for Baby Changing Products for Domestic Use

T/CAB 0115-2021 儿童书包

本文件规定了儿童减负书包的术语和定义、技术要求、试验方法、用户体验评价和检验规则、标志、包装、运输、贮存。

Schoolbag

OENORM EN 1888-2/A1-2021 儿童保育用品 带轮子的儿童交通工具 第2部分：15 公斤至 22 公斤儿童用婴儿车（修正案）

Child care articles - Wheeled child conveyances - Part 2: Pushchairs for children above 15 kg up to 22 kg (Amendment)

FprCEN/TR 16411-2021 儿童护理用品 CEN/TC 252 标准的汇编解释

Child care articles - Compiled interpretations of CEN/TC 252 standards

EN 1888-1:2018/FprA1:2021 儿童保育用品 带轮子的儿童交通工具 第1部分：婴儿车和婴儿车

Child care articles - Wheeled child conveyances - Part 1: Pushchairs and prams

LST EN 13209-1-2021 儿童保育用品 儿童背带 安全要求和试验方法 第1部分：框架背带

Child care articles - Child carriers - Safety requirements and test methods - Part 1: Framed back carrier

21/30440264 DC BS EN 1888-2 AMD1 儿童护理用品 带轮儿童交通工具 第 2 部分：适用于 15 公斤以上至 22 公斤儿童的婴儿车

BS EN 1888-2 AMD1. Child care articles. Wheeled child conveyances - Part 2. Pushchairs for children above 15 kg up to 22 kg

T/HCTCXH 001-2021 汉川市儿童推车评价规范

本文件规定了儿童推车产品评价的术语和定义、评价指标、评价规则和评价结果分级。

Specification for assessment of Hanchuan wheeled child conveyances

EN 1888-2:2018/prA1:2021 儿童保育用品 带轮子的儿童交通工具 第2部分：15 公斤至 22 公斤儿童用婴儿车

Child care articles - Wheeled child conveyances - Part 2: Pushchairs for children above 15 kg up to 22 kg

ISO 11540:2021 书写和标记仪器 - 帽子规范 以减少窒息风险

Writing and marking instruments — Specification for caps to reduce the risk of asphyxiation

SN EN 13209-1-2021 儿童保育用品 儿童背带 安全要求和试验方法 第1部分：框架背带

Child care articles - Child carriers - Safety requirements and test methods - Part 1: Framed back carrier

BS EN 13209-1:2021 儿童使用和保育用品 婴儿运载工具 安全要求和检验方法 后向有框架的运载工具

Child care articles. Child carriers. Safety requirements and test methods. Framed back carrier

DS/EN 13209-1:2021 儿童保育用品《儿童背带》安全要求和试验方法《第1部分：有框背带》

Child care articles – Child carriers – Safety requirements and test methods – Part 1: Framed back carrier