43.120 电车 标准查询与下载

IEC PAS 63454:2022 电动汽车传导充电-直流车辆耦合器配置GG

Conductive charging of electric vehicles - DC vehicle coupler configuration GG

KS R 9223-2022 通勤用电动轨道车车体设计的一般要求

Electric railcars for commuter use ― General requirement for design of bodies

IEC 62196-2:2022 插头、插座、车辆连接器和车辆插座.电动车辆的导电充电.第2部分:交流插脚和接触管附件的尺寸兼容性要求

Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 2: Dimensional compatibility requirements for AC pin and contact-tube accessories

IEC 62196-3:2022 插头、插座、车辆连接器和车辆插座.电动车辆的导电充电.第3部分:直流和交流/直流插针和接触管车辆耦合器的尺寸兼容性要求

Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 3: Dimensional compatibility requirements for DC and AC/DC pin and contact-tube vehicle c

IEC TS 62196-4:2022 插头、插座、车辆连接器和车辆入口.电动车辆的导电充电.第4部分:II类或III类应用的直流插脚和接触管附件的尺寸兼容性和互换性要求

Plugs, socket-outlets, vehicle connectors and vehicles inlet - Conductive charging of electric vehicles - Part 4: Dimensional compatibility and interchangeability requirements for DC pin and contact-t

IEC 63119-2:2022 电动汽车充电漫游服务信息交换 第2部分:用例

Information exchange for electric vehicle charging roaming service？- Part 2: Use cases

IEC 60335-2-114:2022 家用和类似用途电器 安全 第 2-114 部分：个人电动运输车的特殊要求

Household and similar electrical appliances - Safety - Part 2-114: Particular requirements for Personal-e-Transporters

22/30423349 DC BS ISO 8714 电动道路车辆 参考能耗及范围 乘用车和轻型商用车试验程序

BS ISO 8714. Electric road vehicles. Reference energy consumption and range. Test procedures for passenger cars and light commercial vehicles

BS ISO 23828:2022 燃料电池公路车辆 能耗测量 以压缩氢气为燃料的车辆

1   Scope This document specifies the procedures for measuring the energy consumption and driving range of fuel cell passenger cars and light-duty trucks that use compressed hydrogen.

Fuel cell road vehicles. Energy consumption measurement. Vehicles fuelled with compressed hydrogen

T/BJQC 202201-2022 建筑垃圾运输车辆安全管理技术要求

主要包括： 1 范围、 2 规范性引用文件、3 术语和定义、4 一般要求 、5 新能源车辆动力、安全要求、6 车箱结构与密闭、7 车辆智能安全系统 、8 车辆外观与标识、9 车辆检验。  附录 A（规范性） 通讯协议、附录 B（规范性） 驾驶室外部顶灯样式、附录 C（规范性） 放大号牌及新能源标识要求、附录 D（资料性） 车辆外观及颜色、附录 E（规范性） 新车检验。

Technical requirements for safety management of construction waste transportation vehicles

T/CSAE 270-2022 燃料电池电动汽车运行安全监管规范

本文件规定了燃料电池电动汽车数据采集以及安全运行技术要求。 本文件适用于使用压缩气态氢的燃料电池电动乘用车、商用车及特殊作业车。

Monitoring and management specifications for safe operation of fuel cell electric vehicles

BS EN IEC 61851-1:2019 电动汽车传导充电系统通用要求

Electric vehicle conductive charging system - General requirements

BS EN ISO 15118-20:2022 道路车辆 车辆到电网通信接口 第20部分：第二代网络层和应用层要求

1   Scope This document specifies the communication between the electric vehicle (EV), including battery electric vehicle (BEV) and plug-in hybrid electric vehicle (PHEV), and the electric vehicle supply equipment (EVSE). The application layer messages defined in this document are designed to support the electricity power transfer between an EV and an EVSE. This document defines the communication messages and sequence requirements for bidirectional power transfer. This document furthermore defines requirements of wireless communication for both conductive charging and wireless charging as well as communication requirements for automatic connection device and information services about charging and control status. The purpose of this document is to detail the communication between an electric vehicle communication controller (EVCC) and a supply equipment communication controller (SECC). Aspects are specified to detect a vehicle in a communication network and enable an Internet Protocol (IP) based communication between the EVCC and the SECC (see Figure 1). Figure 1 — Communication relationship among the EVCC, SECC and SA Key ...

Road vehicles - Vehicle to grid communication interface - Part 20: 2nd generation network layer and application layer requirements

T/CSAE 262-2022 电动汽车电池管理系统用故障注入测试规范

本文件规定了电动汽车电池管理系统用故障注入测试的测试条件及要求、测试方法及测试结果判定要求等。 本文件适用于电动汽车用锂离子动力蓄电池和镍氢蓄电池的管理系统，其他类型动力蓄电池的管理系统及其他类型车辆的动力蓄电池管理系统可参照执行。

Fault injection test specification for battery management system of electric vehicles

T/CSAE 263-2022 电动汽车驱动电机系统控制器故障注入测试规范

本文件规定了电动汽车驱动电机系统故障测试的测试条件及要求、测试方法及测试结果判定要求等。 本文件适用于符合GB/T 18488.1—2015规定的驱动电机系统。

Fault injection test specification for driving motor system controller of electric vehicles

ISO 23828:2022 燃料电池道路车辆.能量消耗测量.使用压缩氢燃料的车辆

This document specifies the procedures for measuring the energy consumption and driving range of fuel cell passenger cars and light-duty trucks that use compressed hydrogen.

Fuel cell road vehicles — Energy consumption measurement — Vehicles fuelled with compressed hydrogen

BS ISO 6469-2:2022 电力驱动的道路车辆 安全规范 车辆操作安全

1   Scope This document specifies requirements for operational safety specific to electrically propelled road vehicles, for the protection of persons inside and outside the vehicle. Relevant requirements for motorcycles and mopeds are outside the scope of this document, they are described in the ISO 13063 series. This document does not provide comprehensive safety information for manufacturing, maintenance, and repair personnel. This document does not consider specific aspects of driving automation features. NOTE 1 For the definition of the term “driving automation features”, see SAE J3016. EMC is not covered by this document. NOTE 2 For EMC see ISO 11451 and IEC 61851‑21‑1.

Electrically propelled road vehicles. Safety specifications. Vehicle operational safety

T/ZJVITIA 01-2022 《智能车载通讯终端通用技术》

前言　III 1 范围　1 2 规范性引用文件　1 3 术语和定义　1 4 缩略词　2 5 命名　3 6 外观、尺寸和质量以及结构　3 6.1 外观　3 6.2 尺寸和质量　4 6.3 结构　4 7 电气　4 7.1 绝对最大额定参数　4 7.2 推荐工作条件　5 8 功能　5 8.1 一般要求　5 8.2 具体要求　5 8.2.1 安防功能　5 8.2.2 娱乐功能　6 8.2.3 产品维护功能　6 8.2.4 产品自检　6 9 性能　7 9.1 整体性能要求　7 9.2 GNSS模块性能要求　7 9.2.1 频段和通道　7 9.2.2 精度　7 9.2.3 灵敏度　7 9.2.4 首次启动时间　8 9.2.5 位置更新率　8 9.2.6 位置分辨力　8 9.2.7 定位储存　8 9.2.8 速度范围　8 9.2.9 加密速度　8 9.2.10 验证签名速度　8 9.2.11 内置电池工作时间　9 9.3 4G模块性能要求　9 9.4 电源性能　9 9.4.1 电压适应性　9 9.4.2 电源反接性能　9 9.4.3 电源过压性能　9 9.4.4 工作电流　10 9.5 环境适应性　10 9.5.1 气候环境适应性　10 9.5.2 机械环境适应性　10 9.5.3 电荷环境适应性　10 9.6 电磁兼容性　10 9.7 防护等级　10 10 安装　10 10.1 设备主机　10 10.2 天线　10 10.3 线束　10 10.4 安装完成后的检测　11 11 标记、包装、运输和贮存要求　11  

General Technology of Intelligent Vehicle Communication Terminal

EN ISO 15118-20:2022 道路车辆.车辆到电网通信接口.第20部分:网络和应用协议要求

This document specifies the communication between the electric vehicle (EV), including battery electric vehicle (BEV) and plug-in hybrid electric vehicle (PHEV), and the electric vehicle supply equipment (EVSE). The application layer messages defined in this document are designed to support the electricity power transfer between an EV and an EVSE. This document defines the communication messages and sequence requirements for bidirectional power transfer. This document furthermore defines requirements of wireless communication for both conductive charging and wireless charging as well as communication requirements for automatic connection device and information services about charging and control status. The purpose of this document is to detail the communication between an electric vehicle communication controller (EVCC) and a supply equipment communication controller (SECC). Aspects are specified to detect a vehicle in a communication network and enable an Internet Protocol (IP) based communication between the EVCC and the SECC.

Road vehicles - Vehicle to grid communication interface - Part 20: 2nd generation network layer and application layer requirements (ISO 15118-20:2022)

ISO 6469-2:2022 电动道路车辆.安全规范.第2部分:车辆运行安全

This document specifies requirements for operational safety specific to electrically propelled road vehicles, for the protection of persons inside and outside the vehicle. Relevant requirements for motorcycles and mopeds are outside the scope of this document, they are described in the ISO 13063 series. This document does not provide comprehensive safety information for manufacturing, maintenance, and repair personnel. This document does not consider specific aspects of driving automation features. NOTE 1 For the definition of the term “driving automation features”, see SAE J3016. EMC is not covered by this document. NOTE 2 For EMC see ISO 11451 and IEC 61851-21-1.

Electrically propelled road vehicles — Safety specifications — Part 2: Vehicle operational safety